Agri-Fab 45-0364 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Esparcidor Agri-Fab 45-0364. Agri-Fab 45-0364 12 páginas. 250 lb. atv broadcast spreader owners manual
Imprimir página18. Assemble the vinyl grip (T) onto the flow control arm.
See figure 7.
19. Insert the flow control arm down through the slot in the
flow control bracket. Assemble the small hole of the flow
control link (U) to the flow control arm using a 1/4" x 1"
hex bolt (D), a nylon washer (I) and a 1/4" hex lock nut
(F) as shown in figure 7. Tighten carefully. The flow
control link should be snug but should pivot with no
more than slight resistance.
(U) FLOW
CONTROL
LINK
(small hole)
(F) 1/4" HEX
LOCK NUT
(I) NYLON
WASHER
(B) 1/4" x 1"
HEX BOLT
FIGuRE 7
20. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 3/4" hex bolt (D), two
nylon washers (I) and a 1/4" hex lock nut (F). Tighten
carefully. The flow control arm should be snug but
should pivot with no more than slight resistance. See
figure 8.
(F) 1/4" HEX
LOCK NUT
(I) NYLON
WASHERS (2)
FIGuRE 8
(T) VINYL GRIP
(B) 1/4" x 3/4"
HEX BOLT
21. Hook the double bent end of the flow control rod through
the hole in the slide gate bracket located near the bottom
of the hopper. See figure 9.
FIGuRE 9
22. Place a 5/16" flat washer (J) onto the other end of the
flow control rod. Insert the end of the rod through the
curved slot in the flow control mounting bracket and
through the hole in the flow control link. Secure with a
5/16" flat washer (J) and a 3/32" x 3/4" cotter pin (L).
See figure 10.
NOTE: You can leave off the second washer if there is not
enough room on the end of the rod.
FIGuRE 10
23. Place the adjustable stop (R) into the "ON" end of the slot
in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt (E), a nylon washer (I),
a 5/16" flat washer (J) and the nylon wing nut (Q). See
figure 11.
6
(J) 5/16"
FLAT
WASHER
FLOW
CONTROL
ROD
(J) 5/16"
FLAT
(L) 3/32"
WASHER
COTTER PIN