Austere V Series Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Protector contra sobretensiones Austere V Series. Austere V Series 6 páginas.
También para Austere V Series: Manual del usuario (5 páginas)
Connect Your Equipment:
Plug your equipment's power cords into power AC outlets. All Austere Power products feature
expansive SmartFit outlets to accommodate your equipment's transformers without covering
neighboring outlets. It is important to remember that you should NOT plug extension cords
directly into Austere Power. DO NOT OVERLOAD the surge protector's outlets. The surge
protector can accommodate a total equipment load of up to 15 amps (whether plugged into a
single outlet or spread out over multiple outlets). If the load on the Austere Power exceeds 15
amps, the internal circuit breaker will trip, and the outlets will stop providing power. If the
circuit breaker trips, reduce the load by unplugging some devices. Reset by cycling the power
button from On to Off and then On again. Repeat the process of unplugging a device to reduce
the overall load until Austere Power remains On delivering power to all connected devices.
If the Ground LED does not illuminate when plugged in, move Austere Power to a different
grounded 3-prong AC outlet. If this symptom continues, your outlet may not be properly
grounded and needs to be repaired by a professional electrician. When the Ground LED is not
illuminated, your equipment is NOT protected from surge or irregular power events.
Powering your equipment with Austere Power in the absence of Ground LED voids the
Austere Limited Lifetime Guarantee and the Component Guarantee.
If the Protected LED does not illuminate, the AC line is no longer protected from surges, and the
Austere Power unit must be replaced. When the Protected LED is not illuminated, your
equipment is NOT protected from surge or irregular power events. Powering your equipment
with Austere Power in the absence of a Protected LED voids the Austere Limited Lifetime
Guarantee and the Component Guarantee.
USB Charging Ports:
4-Outlet Power
•
The III Series 4-Outlet Power has two OmniPort USBs:
o 1 USB-C, and 1 USB-A, sharing 2.4A.
•
The V Series 4-Outlet Power has three OmniPort USBs:
o 1 USB-C PD 20W
o
1 USB-C, 1 USB-A, sharing 2.4A.
•
The VII Series 4-Outlet Power has three OmniPort USBs:
o 1 USB-C PD 45W
o 1 USB-C PD 20W
o 1 USB-A with dedicated 2.4A.
If both USB-C ports are used, the PD 45W is shared.