DVO ONYX SC Series Manual de instalación - Página 2
Navegue en línea o descargue pdf Manual de instalación para Accesorios para bicicletas DVO ONYX SC Series. DVO ONYX SC Series 11 páginas.
Imprimir página
ENGLISH
Pre-Ride Check
1. Do not ride your bicycle if any one of the following test criteria is not passed! Riding your bike without
eliminating any defect or carrying out the necessary adjustments can result in an accident, serious injury or
even death.
2. Do you notice any cracks, dents, bent or tarnished parts of your suspension fork or any other part of your
bicycle? If so, please contact a trained and qualified bicycle mechanic to check your fork and/or complete
bike.
3. Do you notice any oil leaking out of your fork? Check hidden areas like behind the fork arch under the
crown and main seals. If so, please consult a trained and qualified bicycle mechanic to check your fork or
bike.
4. Make sure your wheels are perfectly centered in order to avoid any contact with suspension fork or brake
system.
5. Make sure the thru-axle system is secure. There should be no play between hub and fork lower. Reference
wheel installation section for proper instructions.
6. Compress your fork with your body weight. If it feels too soft, inflate to the proper pressure to achieve
accurate SAG, inflate until your SAG is between 15-20%. Please also refer to SAG section for more details.
7. Make sure your brakes are properly installed/adjusted and work appropriately. This also applies to every
other part of your bike like handlebars, pedals, crank arms, seat post, saddle, etc.
8. Check the cable length and routing of your components. Make sure they do not interfere with your steer-
ing actions or full compression and extension of your fork.
2
For detailed instructions and videos, visit DVO Tech: tech.dvosuspension.com/setup
Step 1: SAG Setting
SAG is the amount your fork compresses under your body weight (don't for-
get to include your riding gear), also referred to as Rider Weight. Remember
that these are only starting points and adjustments will vary based on rider
ability, trail conditions and personal preference.
After you are done setting up your suspension fork according to the rec-
ommended base settings, check your SAG to make sure you are within the
recommended SAG settings.
The recommended SAG is 15% - 20%. Setting proper SAG
is the only way to find the right air pressure for your fork.
Refer to the chart below to find the proper SAG.
15% SAG
Travel
(Firm)
100 mm (3.9 in)
15 mm (0.6 in)
110 mm (4.3 in)
17 mm (0.7 in)
120 mm (4.7 in)
18 mm (0.8 in)
130 mm (5.1 in)
20 mm (0.8 in)
140 mm (5.5 in)
21 mm (0.8 in)
150 mm (5.9 in)
23 mm (0.9 in)
160 mm (6.3 in)
24 mm (0.9 in)
170 mm (6.7 in)
26 mm (1.0 in)
180 mm (7.1 in)
27 mm (1.1 in)
203 mm (8.0 in)
30 mm (1.2 in)
ENGLISH
SAG RANGE
20% SAG
(Plush)
20 mm (0.8 in)
22 mm (0.9 in)
24 mm (0.9 in)
26 mm (1.0 in)
28 mm (1.1 in)
30 mm (1.2 in)
32 mm (1.3 in)
34 mm (1.3 in)
36 mm (1.4 in)
41 mm (1.6 in)
3
Suspension Set-Up Guide