Agri-Fab 45-0353 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Césped y jardinería Agri-Fab 45-0353. Agri-Fab 45-0353 12 páginas. 3-point hitch trailer
También para Agri-Fab 45-0353: Piezas de reparación (2 páginas)

Imprimir página
LEVELING ADJUSTMENT
ATTACHMENT ADJUSTMENT
_
DO NOT ADJUST
TRAILER
HEIGHT
WITH
ATTACHMENT
RAISED!
PER-
SONAL INJURY CAN RESULT.
The trailer
height must be adjusted
after the trailer
is
attached
to the vehicle to obtain the best performance
out an attached
implement.
Holes in the trailer
frame provide
for a 1-inch
height
change.
Holes in the axle assembly
provide
for a 2-
inch height change. From the lowest setting, the trailer
height can be raised 11 inches. Remove the haircotter
pin to remove the height
adjust pin. Install the pin in
the upper or lower hole of the trailer
frame and the
appropriate
hole of the axle assembly.
Adjust
the
trailer
height
so that
the frame
of the
attached
implement
is horizontal
during operation.
If
the implement
will penetrate
below ground
level dur-
ing operation,
adjust
the trailer
height
so that the
implement
is level while above ground and then lower
the trailer a distance
equal to the approximate
operat-
ing depth of the implement.
Make sure the axle as-
semblies
are set at the same height.
See figure
11.
ADJUST
OPERATING
POSITION
OF
ATTACHMENT
BY
MOVING
AXLE
ASSEMBLY
UP
OR
DOWN
GROUND
SURFACE
OPERATING
DEPTH
ATTACHMENT
FRAME
LEVEL
DURING
OPERATION
FIGURE
11
Use the switch on the tow vehicle
to raise or lower the
attachment.
Push the "rope in" button on the switch to
raise the attachment.
Push the "rope out" button on
the switch to lower the attachment.
When
the attachment
is in the lowered,
operating
position,
there should
be slack in the wire rope allow-
ing the implement
to follow the contour
of the ground.
MAINTENANCE
1.
Check for and tighten any loose hardware
before
each use.
2.
Lubricate
both wheel axles with grease before use
each season.
3.
Inspect wire cable on winch before
each use and
replace
cable if necessary.
4.
Refer
to user's
guide
provided
with
winch
for
winch maintenance.
5.
Remove
all dirt and rust. Touch
up paint before
placing
hitch trailer
in storage.
6.
Store hitch trailer
inside a dry area.