Dateq XTC II Manual - Página 9

Navegue en línea o descargue pdf Manual para Equipo para DJ Dateq XTC II. Dateq XTC II 19 páginas.

DATEQ XTC II manual

Operation

Besides the four fader channels the XTC II is equipped with a extra microphone

channel. This DJ channel uses a volume potmeter (LVL) instead of a fader.

The microphone input comes with a (low-voltage) phantome supply, controlled by a

internal jumpersetting.

To prevent from an acoustical feedback it is possible to filter out the microphones

signal (Cleanfeed) from the monitor speakers. This controlled by internal

jumpersettings.

Both a microphone and a line-source can be connected to the back as well as the

front and selected with the input source selector (top button).

This channel has a 3-way tone control. All the equalisers have a +/- 15dB range.

The overload detector (OVL) for input and pre-fader is situated on the front-panel.

Pre-fade listening is controlled by the CUE-switch.

∞

Fader channels

The XTC II has four identical fader channels. The first three can be connected to a

stereo line source, and a turntable. The fourth channel can be connected to two

stereo line sources. The source can be selected with the input-source selectors (top

switch) The three phono-level channels can be changed to line-level by internal

jumper settings.

The three-way tone control ranges from -32dB ... +8dB. This means that certain

frequencies will be almost completely suppressed when the equaliser is set to a

minimum.

With the FX effect button it is possible to route a channel very quickly to the

connected effect device. Pushing the effect button sends the pre-fader signal to the

effect unit. The processed signal (so with the effect) becomes available at the

channels fader and can be added to the mix.

If the effect return signal is NOT present the XTC II 's own send signal is being used

instead, shown by a blinking FX indicator.

Pre-fade listening is controlled by the CUE-switch. This will feed the channel pre-

fade or effect return signal depending on the FX button

Just above the fader there are indicators for cross fader routing and source signal

presence.

∞

Note: for all jumper settings see the Setup chapter.