Agri-Fab 45-01012 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Carrito de exterior Agri-Fab 45-01012. Agri-Fab 45-01012 12 páginas. Utility carts
Imprimir página
13. Insert a flange bearing into each side of the tongue as
shown in figure 9.
FLANGE BEARING
FLANGE
BEARING
FIGURE 9
14. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside down
on its top flanges, so that the wheel support is facing
up. See figure 10.
15. Lay the drawbar tongue (open side facing up) onto the
Wheel Support and the Latch Stand Bracket. Assemble
the axle through the wheel support and the tongue. See
figure 10.
AXLE
FIGURE 10
TONGUE
DRAW BAR
TONGUE
LATCH STAND
BRACKET
16. Place the latch lock lever through the slot in the draw
bar tongue as shown in figure 10. Assemble the 5/16"
x 3-3/4" hex bolt through the tongue, the lever and two
5/16" hex nuts (SEMS) (one on each side of the lever).
Assemble the 5/16" hex lock nut onto the end of the
bolt and tighten so that the bolt can still rotate freely.
Tighten the two 5/16" nylock nuts against the sides of
the latch lock lever so that the lever is centered in the
slot. See figure 11.
5/16" HEX NUTS (SEMS)
5/16" x 3-3/4"
HEX BOLT
FIGURE 11
17. Hook the short end of the spring into the hole in the
latch lock lever. Use the spring puller tool to hook the
long end of the spring into the square hole in the tongue.
The spring puller tool can be stored when finished. See
figure 12.
SPRING PULLER TOOL
FIGURE 12
IMPORTANT:
Make sure drawbar tongue is securely
locked to the latch stand bracket by the latch lock lever.
6
LATCH
LOCK
LEVER
5/16"
NYLOCK
NUT
LONG END
OF SPRING
LATCH LOCK LEVER