Cookology CITFZ177 Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Congelador Cookology CITFZ177. Cookology CITFZ177 15 páginas.
Imprimir página
1.Environmental
Proper Disposal
Packaging Materials
The applianc e is packaged in a way to prevent damages
during transportation. Recyclable materials are used.
The carton is made of corrugated board / cardboard
(mainly from recycled paper).
·Polystyrene parts (CFC-free foamed polystyrene)
·Linings and polyethylene bags
·Polypropylene straps
All these valuable materials may be taken to a
collecting centre and used again after adequate recycling.
All waste materials should be disposed of correctly.
2.Location
Make sure the freezer is kept upright during handling. If
tilting is required, it should
otherwise the appliance may be damaged, resulting in
compromised refrigeration performance.
To avoid product damage or personal injury, the
refrigerator sh ould be unpacked by two per sons after it is
located in the required location.
Before installation, make sure the refrigerator has no
visible exterior damage.
When handling the appliance, do not lift it by holding the
doors, to prevent any damage to the refrigerator.
Do not start up a refrigerator that is damaged.
Check the refrigerator carefully for:
·Damaged package due to inappropriate handling
during transportation
Damage to the exterior
·Damage to the power cable / plug
If in doubt, please contact Customer Service for a
thorough check-up of the appliance.
Take
necessary
measures
refrigerant at the start-up of the refrigerator, which may
result in environmental pollution.
Protection
and
waste
not exceed
45 degrees,
to
prevent
leakage
3.Installation
a) Remove all packaging materials.
b) Remove any items inside the freezer.
c)
Ensure that all film and tape on the cabinet and the
door is removed.
d) Remove polystyrene chips (if any) around the freezer.
e) Take out accessories and literature from the freezer.
f)
Clean the inside of the freezer with lukewarm water
and vinegar and then dry it with a soft cloth.
g) Use the spanners supplied to adjust the levelling leg to
ensure the freezer is stable.
Do not use detergents, sharp or pointed instruments
or soda-based cleansers to clean the refrigerator.
· Before installation, make sure the refrigeration system is
free of any damage.
· The freezer should be used for its intended purpose
only.
· The freezer should be positioned on a solid and even
floor to ensure refrigerant circulation and good
refrigerating performance.
· If possible, position the freezer in a cool and dr y well
ventilated room.
· Do not expose the freezer to direct sunshine and ensure
the ambient temperature is not too high.
· Keep the freezer away from heat sources, such as
heating systems, ovens or cookers. Otherwise, the
compressor will operate more frequently resulting in
extra power consumption.
If the freezer is placed near a heat source, it is
recommended to install a thermal barrier between the
appliance and the heat source (asbestos is prohibited) or
maintain adequate space between the freezer and heat
source as follows:
Cooker or Stove
Radiator or Oven
Another Refrigerator
Do not place any radiating apparatus, such as a
microwave oven, on top of the appliance.
Make sure the air vent is not obstructed.
Never unplug the refrigerator by pulling on the power
cable. Always switch off at the mains, then grip the plug
of
firmly and pull it strai ght out from the socket.
2
3 cm
30 cm
2 cm