AUSTRALIAN MONITOR ES Series Manual de instalación y funcionamiento - Página 6

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Mezclador AUSTRALIAN MONITOR ES Series. AUSTRALIAN MONITOR ES Series 13 páginas. Rackmount mixer
También para AUSTRALIAN MONITOR ES Series: Manual de instrucciones (17 páginas)

Imprimir página

REAR PANEL

CH 1-4

Each channel input section has two inputs:

XLR input – This is a balanced microphone input with an input sensitivity of 1.2mV.

RCA input – This is an unbalanced line level input. It has an input sensitivity of 160mV. The two RCA sockets are summed to

mono internally.

REC OUTPUT

The REC output is on unbalanced RCA connectors. The output level is 220mV into 10kΩ at rated output. The output is dual

mono.

NOTE: The output is not affected by the MASTER volume control or the BASS and TREBLE controls.

The output also does not receive the signal from the tone generator.

LINE OUTPUT

The LINE output is on a balanced XLR connector. The output level is 0.775V into 1kΩ at rated output.

NOTE: The tone generator output will also be fed into the line output if activated.

When wiring the LINE output as unbalanced, Pin2 should be wired as hot and Pin1 should be wired as ground/ shield. Do not wire Pin3.

POWER INPUT CONNECTOR

Your mixer is powered via a 24VDC 0.5A universal power adapter. The power adapter is included with your mixer. The DC

input accepts a 5.5/2.1mm plug with tip positive and ring negative connection.

PHANTOM POWER

12V phantom power is available for condenser or electret microphones on the XLR input when this switch is pushed down.

ES SERIES INSTALLATION AND OPERATION MANUAL

5,6