ADE Optima G3 Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Sistema de seguridad ADE Optima G3. ADE Optima G3 17 páginas. Intruder alarm system

How To Reset After An Alarm

After any alarm you will need to reset your system so that it can be used normally. Your installer

may have programmed the system to be reset by you, the installer, or by Anti-code.

Reset

Press the

If the Zone, TA (Tamper) or PA (Attack)

indicators all go out and the Day indicator

lights then the system has been reset.

If any of the indicators continue to flash then

the system has been programmed to be reset by

the installer. In this case you must call the

installer to reset the system.

If all indicators light steady (not flashing), and

the keypad stops working, then the system has

entered a fault-lockout. You must call the

installer rectify this fault.

The installer may instruct you to reset the system by an Anti-code.

Reset

Press

. The system will now display a

sequence of 4 numbers by using the Zone

indicators. Each number will be displayed for a

few seconds, the system will beep, and display

the next number. You can repeat this sequence

by pressing Reset again. Write down the

4 digit number and quote it to the installer

The installer will tell you a 6 digit anti-code.

Key in the 6 digit code to reset the system.

key.

Accenta/Optima G3 intruder system

Strobe Off

1 2 3 4 5 6 7 8

ZONES

Panel

ZONE

Remote Keypad

Call your installer for the anti-code.

Power

Attack

Tamper

Day

Power