4x4 TOUGH 150L Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Compresor de aire 4x4 TOUGH 150L. 4x4 TOUGH 150L 12 páginas.

OPERATION

• When operating the unit, be sure to be in a safe location o the road

and away from tra c.

• Unpack the unit and inspect for damage. Completely unwrap the

power cord.

• Make sure that vehicle engine is running and place the unit on a dry

level surface.

• Connect the air supply hose to the unit using the quick connect tting.

(See Picture 1. below)

1. Slide retaining snap ring back.

2. Slide the ttings together rmly.

3. While holding ttings together rmly slide the outer ring forward to lock.

Air hose connection

• Connect the red alligator clamp to a positive 12 volt source. Connect

the black alligator clamp to a negative ground point. Do not connect

the black alligator clamp directly to the battery.

• Test the connections by switching the compressor to "on". Air will

begin to ow.

• Connect the air hose by screwing the brass in ator onto the tyre valve

stem. Only nger tighten the in ator. Do not use any tool as you may

damage the in ator or the valve stem.

• Watch the gauge closely and switch the unit o or remove the in ator

from the tyre when the manufacturer's recommended pressure has

been achieved.

• Allow the compressor to cool before replacing neatly into the plastic

storage case with the alligator clamps and adaptors secured into

cavaties provided.

• Store the unit in a dry location.

• Remember to replace the valve cap onto the stem of your valve.

• Turn the compressor on before connecting to the tyre in order to

reduce stress on the motor.

• Use for a maximum of 20 minutes then allow to cool for 20 minutes.

• To prevent damage to the air hose tting, remove the in ator from

the tyre before disconnecting the hose from the compressor.

Picture 1.