Bresser BR-S COB LED Manual de instrucciones - Página 3
Navegue en línea o descargue pdf Manual de instrucciones para Equipos de iluminación Bresser BR-S COB LED. Bresser BR-S COB LED 13 páginas. Led lights
También para Bresser BR-S COB LED: Manual de instrucciones (13 páginas)
Imprimir página
Fig. 1
DELIVERY CONTENT
LED Light (A), remote control (B), power cable (C)
PARTS OVERVIEW
LED LIGHT (A)
Slide for S-bayonet release
When turned on, the brightness range is 10-100%
Notches for accessories with S-bayonet connector
LED Light source
Holes for accessory rod (e.g. for umbrella)
Handle
Control panel
LCD
Adjustment knob
• Press to set desired channel (1-99)
• Turn to set desired brightness (10-100%)
Fixing screw (tripod connection)
Vents
Power slider
Power connection socket
Locking screw (tilt joint)
Tripod connection
REMOTE CONTROL (B)
LCD
Power knob
– knob
Menu knob
+ knob
Battery compartment
POWER CABLE (C)
Euro plug
C13 plug
B
(Fig. 1)
(Fig. 1)
A
ESTABLISHING THE POWER SUPPLY
1. Insert the C13 plug (22) of the power cable (C) into the
power connection socket (12) on the LED light.
2. Insert the Euro plug (21) of the power cable (C) into the wall
socket.
SWITCHING ON/OFF THE LED LIGHT
1. Establish the power supply for the device.
2. Slide the power slider (11) to the 'ON' position to switch on
the device. The lighting is switched on with the settings of
the last use.
3. Slide the power slider (11) to the 'OFF' position to switch
off the device. The last settings made are retained until the
device is switched on again.
Important: Disconnect the device from the power supply if it
is not going to be used for a long period of time!
ADJUSTING THE BRIGHTNESS
1. Turn the adjustment knob (8) clockwise to increase the
brightness.
2. Turn the adjustment knob (8) counterclockwise to decrease
the brightness.
SETTING UP THE CHANNEL
1. Press the adjustment knob (8) several times until the
desired channel is shown in the display.
Note: Make sure to set the same channel on the device as well
as on the remote control. To control different devices at the
same time, use the same channel for all devices. If you want
to control more devices at different times, use a different
channel for each device.
C
*not included