BENDIX AH-4 Manual - Página 4

Navegue en línea o descargue pdf Manual para Piezas de automóviles BENDIX AH-4. BENDIX AH-4 6 páginas. Air hydraulic intensifier

4-5/8

FIGURE 3

ASSEMBLY

Rotochamber

1. Position the diaphragm on end in the inner diaphragm

clamp (Fig. 1). The smaller diameter end of the

diaphragm should be against the diaphragm clamp.

2. Place and install the diaphragm guide within the

diaphragm and over the inner diaphragm clamp studs.

3. Install the push plate push rod assembly within the

diaphragm guide and over the inner diaphragm clamp

studs.

4. Install nuts on the inner diaphragm clamp studs and

tighten securely (55-70 inch pounds)

5. Place the assembly consisting of the push rod, push

plate, diaphragm guide, diaphragm, and inner clamp

inside of the outer clamp.

6. Roll the free end of the diaphragm back and over the

end of the outer diaphragm clamp.

7. Lubricate the inside wall of the body and the rolled

surface of the diaphragm with BW652M Type 2.

8. Slide the above assembly into the body. The end of the

diaphragm should fit snugly against the shoulder in the

body. Position the outer diaphragm clamp studs through

the holes at the end of the body, install nuts and tighten

securely. Torque to 100-125 inch pounds.

9. Install spring guide, and install spring over push rod.

10. Install cover over push rod and into body. Attach cover

to body with cap screws, tightening securely. Torque to

110-150 inch pounds.

3/8 X 18 BOLT

3-1/8

C.R.S.

4-5/8

FIGURE 4

FIGURE 5

ASSEMBLY

Master Cylinder

1. Wash the cap nut, adapter block, and cylinder castings

with alcohol or mineral spirits and dry thoroughly.

2. Carefully clean the filter screen. (6)

Continued on Page 5.