dymax 110 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Unidad de control dymax 110. dymax 110 20 páginas. Spray valves

10. Using a seat wrench, unthread and remove the Seat (B) and the 007 Kalrez® O-Ring

(V).

NOTE:

The teeth of the seat wrench are tapered so the wrench will only fit on one

side.

11. Clean all of the wetted parts thoroughly with an appropriate solvent.

12. On the Air Section (A), remove the final two Machine Screws (P) that thread into

the End Cap (H) by using a standard 3/32" Allen key.

NOTE:

During removal, the Spring (T) will force the Air Section apart.

13. Separate the Upper Air Body (M) from the Lower Air Body (I) and remove the

Spring (T).

14. Slide the End Cap (H) off the Needle (C).

15. Holding the Lower Air Body (I) in one hand, grab the Needle (C) and push the

Needle and Piston (K) assembly out of the Lower Air Body (I).

16. Remove the 004 Buna O-Ring (S) from the Lower Air Body (I).

17. Hold the Piston (K) with an adjustable wrench and use a 5/64" Allen key to

unthread and remove the Set Screw (U).

18. Remove the Needle (C) and the 014 Buna O-Ring (J) from the Piston (K).

19. Remove the 014 Buna O-Ring (J) from the Upper Air Body (M) and the 008 Buna O-

Ring (L) from the Stroke Adjuster (O).

20. Unthread the Stroke Adjuster (O) from the Upper Air Body (M) and remove the 008

Buna O-Ring (L).

21. Replace all worn components with new components.

Dymax Model 110 & 210 Spray Valves User Guide