Gacell C3-CHG-01-00-00 Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Cargador de batería Gacell C3-CHG-01-00-00. Gacell C3-CHG-01-00-00 3 páginas. Concens c3 nimh battery charger for nickel-metalhydrid (nimh) batteries
Imprimir páginaThe yellow LED lights up when the charger is connected to power. Place the battery in the charger by sliding it in
and rotating it until it is pulled into place by the magnets. The green LED will flash at approx. 1 second intervals
while the battery is being charged. Once charging is complete the green LED remains permanently lit. Remove the
battery by rotating it 90 degrees. It will then be ejected and be ready for use in the C3 controller.
When the battery requires recharging, transfer it to the charger as described above. It is recommended that you
keep an extra battery on hand to avoid disruption to operation.
5. Tips
It is recommended that you follow the tips below to achieve the best results and avoid problems in daily operation.
General:
If the battery's safety thermostat is activated due to overload, the battery must be allowed to cool for at least
half an hour before being charged or used again. A new battery may be inserted into the controller after one
minute.
Always wait at least two seconds after the last actuator has stopped before removing the battery from the
controller. Otherwise controllers using position feedback may not have time to store the position, and the
controller will have to be 0-point calibrated again.
Batteries:
Always use batteries which are in good condition and fully charged when inserted into the controller.
You can extend the lifetime of the battery by occasionally recharging it even though it is not fully discharged.
If the battery level drops below the critical level and the system shuts down, you must wait at least one
minute before inserting a different battery and using the system again.
If the system is not to be used for an extended period (several days or weeks), the battery should be
removed from the controller to avoid deep discharge, which can cause lasting damage to it.
Handling:
Avoid getting metal shavings or other magnetic objects on the battery poles or in the charger.
User Guide C3-CHG-01-xx-00 Rev. 01
Battery mounted in the controller – ready for use
GACELL A/S - Sletten 17 - DK 7500 Holstebro - 961 02 961
Page 3 of 3