Gacell SLH 26C Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Cargador de batería Gacell SLH 26C. Gacell SLH 26C 20 páginas. Single-phase high frequency battery charger

Imprimir página
USER MANUAL
USER MANUAL
GENERAL INFORMATION AND WARNINGS
1. Automatic digital battery charger suitable for all types of batteries.
2. Fully automatic charging cycle with electronic adjustment.
3. Refer to previous paragraph INSTALLATION AND SAFETY WARNINGS for instructions on the correct
installation and use modes of the battery charger.
4. Ensure that the available mains voltage corresponds to that of the battery charger, as indicated in the serial
plate.
5. Ensure that the battery voltage corresponds to that of the battery charger, as indicated in the serial plate.
6. Carefully follow every instruction provided by the manufacturer.
7. The DB9 connector located near the signaling LEDs IS NOT A NORMAL SERIAL CONNECTOR AND MUST
NEVER BE CONNECTED DIRECTLY TO THE SERIAL PORT OF A PC

OPERATION

-
Insert the power cable plug into the socket.
-
Connect the battery respecting the polarity.
-
At this point a test on the battery voltage is carried out to decide whether to start the charge or not.
-
If the battery is not connected to the battery charger, yellow LED blinking.
-
If, on the other hand the battery is connected, the yellow LED blink 3 times and then the charge will begin
in first charging phase with green LED blinking.
The progress of the charge cycle is indicated by three LEDs:
LED INDICATION in STANDALONE MODE
Ref.
Power supply from mains only
F1
Stage 1 :
Constant current initial charge
F2
Stage
2: Constant voltage final charge
F3 (*)
Stage
3: Final charge Stage F3
Stage
4: Final charge Stage F4
F4 (*)
(if present)
Charge complete
FAILURES
LED INDICATION in CAN MODE
Ref.
Power supply from mains only
Battery connected, IDLE, Stand by
Charging, Run
Charge complete, EOC
FAILURES
Signals
Signals
DL3
"Battery
"Final charge in
connected" LED
progress" LED
DL1 (green)
DL2 (yellow)
OFF
BL
BL
BL
BL
ON
OFF
"Battery
"Final charge in
connected" LED
progress" LED
DL1 (green)
DL2 (yellow)
OFF
OFF
ON
ON
OFF
Revisione n° 3 del 26/07/2021
DL2
DL1
"Failure"
LED
DL3 (red)
BL
OFF
OFF
OFF
ON
OFF
BL
OFF
BV
OFF
ON
OFF
OFF
ON
"Failure"
LED
DL3 (red)
BL
OFF
ON
OFF
OFF
OFF
ON
OFF
OFF
ON