Gadhouse MATHIS Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Plato giratorio Gadhouse MATHIS. Gadhouse MATHIS 12 páginas.

Imprimir página

1.Slip the loop of the anti-skating

weight's thread over the 3rd

groove of the stick to set correct

anti-skating force for the

factory-ﬁtted cartridge.

OPERATION

INPUT

Turntable Function (LP)

Press the Power Switch to turn on the power.

2. Place the record on the turntable. Use the 45 RPM Adapter if necessary.

3. Remove the stylus protector from the stylus assembly.

Note: To avoid stylus damage, make certain the included stylus guard is

in place whenever the turntable is being moved or cleaned.

4. Open the tonearm clip from left to right.

5. Gently pull up the tonearm from its rest and move it over the record

where play is desired to begin. Use the Tonearm Lift Lever to raise the

Tonearm Lift and let the tonearm sit on it.

Note: The platter will auto start when the Tonearm leave the its rest

6. Set the Tonearm Lift Lever back to the down position, the tonearm will

descend slowly onto the record and begin playback.

7. When the record is ﬁnished playing, use the Tonearm Lift Lever to raise

the tonearm and then return it to the tonearm rest. To suspend the

playback, repeat the same steps.

2.Feed the thread through the loop

of the wire hanger.

OUTPUT

1. Bluetooth Transmitter Operation

This turntable has a Bluetooth transmitter to wirelessly send audio to

Bluetooth speaker.

Power on your Bluetooth speaker and ensure it is in pairing mode.

2. Power on the turntable. BT will auto search when the turntable turns on

and the BT LED indicator light will ﬂash.

3. When pairing, the light will ﬂash twice per second and will become solid

when paired successfully.

4. To disconnect pairing, power off the turntable to turn off Bluetooth

pairing on your Bluetooth speaker.

5. This turntable will connect to the nearest Bluetooth speaker.

If after 2 minutes no Bluetooth speaker can be found to pair with,

the Bluetooth transmitter will become inactive and the LED will

turn off. If you need to connect again, power off the turntable and

the speaker then power on again.

Bluetooth Indicator

Bluetooth Status

Flash

Auto searching and pairing

Solid

Paired successfully

Off

Inactive

2. Connection to the Ampliﬁer

This turntable uses a moving magnetic cartridge. Set the PHONO & Line

Out Switch on PHONO Position. Connect the phono out cables to the

phono input on your ampliﬁer of pre-ampliﬁer (phono stage). Line inputs

such as CD, Tuner, Tape, or Video are not suitable for phono inputs.

Make sure the ampliﬁcation of the selected input matches the type of

cartridge being used. The factory installed cartridge is 47k ohms/MM-input.

NOTE: If your ampliﬁer does not have an input suitable for phono cartridges,

you will need to purchase a separate phono ampliﬁer for moving magnetic

cartidges. This separate phono ampliﬁer will then connect between your

turntable and your ampliﬁer.