5G HUB 5G NB-IOT USB KIT Especificaciones y manual de usuario - Página 12
Navegue en línea o descargue pdf Especificaciones y manual de usuario para Hardware informático 5G HUB 5G NB-IOT USB KIT. 5G HUB 5G NB-IOT USB KIT 14 páginas. Usb dongle bc660
Imprimir página2.8 Powering the USB dongle
The BC660 module can be powered through USB or through external battery power source. To power it
through USB, connect PIN 1 and PIN 2 (and disconnect PIN 2 and PIN 3) on the USB/BATT power jumper
then plug the USB dongle into a USB port on a PC. The USB port provides power to the USB dongle and
BC660 module.
If the BC660 module is to be powered from external battery power source, then connect PIN 2 and PIN 3
(and disconnect PIN 1 and PIN 2) on the USB/BATT power jumper. No need to plug the USB dongle into
USB port on PC since the power is provided through the external battery power source.
Figure 7. USB/BATT jumper
2.9 Connecting UART to the USB Dongle
You interface with the USB dongle through UART interface. The UART (TXD/RXD) can be connected to any
external device with UART (Tx/Rx) interface such as an Arduino board or any other hardware board
available.
You connect the USB dongle through TXD and RXD, to a USB port in the computer through a USB-to-
UART cable. You can use cable such as this one:
USB TO UART TTL (Wires) Serial Cable (PL2303HX) MCP00102W Programmer Arduino Compatible in
Elecrow bazaar!
Such a cable has multiple colored wired, and you connect them to pins on USB dongle as follows:
White: TXD
Green: RXD
12
USB Dongle Rev 1.0
Copyright © 5GHUB.US