Active Products ZE03 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Lavadora a presión Active Products ZE03. Active Products ZE03 16 páginas. 1650psi everyday pressure washer

Imprimir página
ASSEMBLY AND OPERATING INSTRUCTIONS
Assembly Time: 2 minutes / Tools Required: None
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects which could create a
hazard. Remove from the workarea which could be tripped over, such as toys or outdoor furniture.
Ensure that all doors and windows are closed tight.
Caution
Never use the pressure washer to draw in
•
water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
Dirt in the feed water will damage the unit.
•
To avoid this risk, we recommend
checking the water filter (located inside
the water inlet; to clean it out see
Maintenance section on page 11).
Always prevent debris from being drawn
•
into the unit by using a clean water
source and an accessory water filter if
required.
O / OFF
Step 1
Make sure that the ON/OFF switch is in the
"OFF" position.
Step 3
Insert the wand into spray gun, and twist 1/4 turn until rectangular tab appears.
4
Water Supply (Cold Water Only)
Do not draw non-water liquids through the unit. For
•
use with cold water supply only.
Water hose must be at least a 1/2" in diameter.
•
Flow rate of water supply must not fall below 2 GPM
•
(gallons per minute).
Flow rate can be determined by running the water
•
for one minute into an empty 5-gallon container.
The water supply temperature must not exceed
•
104°F (40°C).
To prolong the life of the unit, it is
recommended to rest the unit 5 minutes
after every 30 minutes of use.
I/ON
Step 2
Separate the adaptor and quick-connect
coupling. Attach inlet adaptor to the machine's
inlet and attach the quick-connect coupling
onto the garden hose.
Caution