Dyna-Glo DGC310RNP-D Manual - Página 15

Navegue en línea o descargue pdf Manual para parrilla Dyna-Glo DGC310RNP-D. Dyna-Glo DGC310RNP-D 17 páginas. 3-burner lp gas grill

OPERATION INSTRUCTIONS

CHECKING FOR LEAKS

After all connections are made, check all connections and fittings on the LP gas tank valve, gas hose

and regulator for leaks with a water and soap solution.

To prevent fire or explosion while testing for a leak:

• Always perform leak test prior to lighting the grill.

• Do not smoke while testing for a leak.

• Always perform leak tests outdoors in a well-ventilated area.

• Do not use any source of flame while testing for leaks.

• Do not use the grill until any and all leaks are corrected.

• If you are unable to correct a leak, disconnect the propane supply and call a gas appliance service

dealer.

PERFORM LEAK TEST

• Prepare leak test solution by 50/50 ratio of liquid dish soap and water.

Total solution required is approximately 2 - 3 ounces (70 - 90 ml).

Put leak test solution in a spray bottle.

• Ensure all control knobs are in the

• Connect the gas hose to the gas supply.

• Open the LP gas tank valve.

• Spray leak test solution on all gas carrying connections and fittings. Presence of bubbles at areas

of applied test solution indicates a gas leak. If leaks are detected or you smell or hear gas, shut off the

gas supply valve immediately and repair or replace the defective part. Do not use the grill until

all leaks are corrected.

Only use the regulator and hose assembly provided! If a replacement is necessary, please call

our customer service center. Do not use replacement parts that are not intended for this grill.

ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED TO

PREVENT FIRE, DAMAGE AND/OR INJURY.

OFF position.

CAUTION

WARNING