Dawes Cycles bike Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Bicicleta Dawes Cycles bike. Dawes Cycles bike 16 páginas.

Imprimir página
To ensure your safety:
•
Do not ride on the same side of the road as oncoming traffic.
•
Do not ride two side by side.
•
Do not carry a passenger unless cycle is equipped to do so.
•
Do not swerve in and out of traffic.
•
Do not hang items over the handlebars to impede steering or catch in the front wheel.
•
Do not hold on to another vehicle.
•
Do not ride too close behind another vehicle.
CAUTION: Wet Weather Riding No brakes work as well under wet or icy conditions as they do under dry conditions. In
wet weather special precautions must be taken to assure safe stopping. Ride slower than normal and apply your brakes
well in advance of anticipated stops.
CAUTION: Night Riding We recommend you minimise the time you ride after dark. If you should have to be out on your
bicycle at night you must comply with the law, use a headlight (white) and a tail-light (red) on your bicycle in addition
to the all-around reflectors that are fitted. For added safety wear light coloured clothing with reflective stripes.
Check that the bicycle reflectors are firmly secured in their correct position, clean and not obscured. Damaged reflectors
must be replaced immediately.

Riding Position

It is important that you and your bicycle are fitted to each other, not only for comfort and riding ease but for control and
safety. Normally your Dealer will custom fit your bicycle to you but the following few pages should help you to find your
most comfortable, safe and efficient position.
SEAT
Seat Adjustment
Loosen the nut on the seat-post clamp enough to allow the saddle to move backwards or forwards. The seat can then be
aligned and the angle can also be adjusted (it is recommended that the seat be parallel to the ground).
To adjust the seat up and down, loosen the binder-bolt on the seat tube, position the seat and re-tighten the binder-bolt.
CAUTION: Insert the seat-post to a point above the insertion mark. The MINIMUM INSERTION MARK should not be
visible. Securely tighten the seat-post binder bolt/nut by using an Allen key or a 13 mm spanner. Test by grasping the seat
and attempting to turn. Keep tightening until the seat will no longer turn. Refer to table of recommended torque values on
page 8.
WARNING: Bicycle should not be ridden if seat adjustments are not properly tightened.
Allen head
Binder-bolt
Normal 13mm
Binder-bolt
Seat tube
Seat Post
Saddle
Minimum
Insertion mark
End of
Seat Post
Seat Angle
Seat
frames.Take care when inserting seat post
that the protruding end cannot interfere with
the frame suspension unit during use. If in
doubt consult your dealer about adjustment.
6
Seat
posts
according
types and accordingly
the procedure for fitting
varies. If in doubt consult
your dealer.
Post
adjustment—
Suspension
differ
to
saddle