Gage Bilt 4C-615A-61 Manual de inicio rápido - Página 4
Navegue en línea o descargue pdf Manual de inicio rápido para Herramientas Gage Bilt 4C-615A-61. Gage Bilt 4C-615A-61 4 páginas.
Imprimir página
INSTALLATION INSTRUCTIONS
FOR ATTACHING TO GB715 TOOL
1. Make sure the head piston of the tools is in its full forward position
2. Connect power tool to air supply before attaching pulling head
3. Thread the pulling head onto the head piston and tighten jam nut (28)
INSTALLATION INSTRUCTIONS
FOR ATTACHING TO GB784 TOOL
For 5/32"-1/4" - Do NOT use GB784 to install 1/8" CherryLOCK rivets.
1. Connect power tool to air supply and make sure head piston of
the tools is in its full forward position
2. Tighten Jam nut (70411)
3. Install adapter (784715) to the tool.
Adapter
(784715)
Cherrylock® is a registered trademark of Cherry Aerospace Fasteners. Lubriplate® is a registered trademark of Friske Brothers Refining Co.
GAGE B I LT
● 615A-61 Pulling Heads
Seller warrants that all goods covered by this catalog will conform to
applicable specifications and will replace or repair, EXW. our plant, any
goods providing defective from faulty workmanship, or material, for 1 year
.
from date of shipment
Said warranty to remain in effect if, and only if, such goods are used
in accordance with all instructions as to maintenance, operation and use, set
forth in manuals and instruction sheets furnished by seller.
Sellers obligation under this warranty shall be limited to the repair or
rework of the goods supplied or replacement thereof, at Seller's option, and
in no case is to exceed the invoice value of said goods. Under no
circumstances will the seller be liable for incidental or consequential
damages or for damages incurred by the buyer or subsequent user in
repairing or replacing defective goods or if the goods covered by this
warranty are reworked or subjected to any type of additional processing.
This warranty is void if Seller is not notified in writing of any
rejections or defects 1 year after the receipt of the material by the customer.
THIS WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES
EXPRESSED OR IMPLIED, INCLUDING MERCHANTABILITY.
INSTALLATION INSTRUCTIONS
FOR ATTACHING TO GB784 TOOL cont.
Note: The shift point setting on the tool must be adjusted to
compensate for the longer stroke when using adapters.
4. Remove limit pins.
5. Turn adjusting knob counter-clockwise until it stops.
The GB784 will now install Cherrylock rivets upt to 1/2" grip
length. Before using a straight 681 series pulling head again,
the tool must be re-adjusted using stroke setting gage (784159).
See GB784 tool manual for instructions.
WARRANTY
4
Adapter
(784715)
Adjuster Knob
Limit Pin
Rev. 3/18