Gage Bilt GB106 Series Manual de instrucciones original - Página 13

Navegue en línea o descargue pdf Manual de instrucciones original para Herramientas Gage Bilt GB106 Series. Gage Bilt GB106 Series 16 páginas. 16v battery installation tool

Imprimir página

Providing all maintenance conditions have been met, follow this systematic approach to diagnosis.

1. INSTALLTION TOOL STOPS AND A RED LED COMES ON.

a.) Fasteners are used beyond the specified performance capability of the tool. Wait until the LED goes out and press the

actuator assy (VP1316) briefly again. The tool then moves to its starting positions.

2. THE INSTALLATION TOOL COMPLETES THE CYCLE THEN STOPS.

a.) The battery (VP1309) is dead. The tool is protected by a protection circuit. The LED lights up yellow. Replace the battery

with a fully charged one. The yellow LED goes out and you can continue working.

THE INSTALLATION TOOL DOESN'T WORK WITH A FULLY CHARGED BATTERY.

a.) Ensure mandrel collection bottle (VP1002) or cover cap (VP1321) is securely mounted and fully engaged in the rear of the

installation tool activating the safety switch. (See page 9).

THE LED FLASHES ALTERNATELY RED AND YELLOW.

a.) An incorrect battery was installed. Replace the battery with a battery of correct voltage.

GB106 16V BATTERY INSTALLATION TOOL SN: 1067 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

TROUBLESHOOTING

Fault Indicator (Red / Yellow LED)

Image may not reflect actual tool

Cover Cap (VP1321)

7/21 REV 8/21