Gage Bilt GB703SRVT/4N6E Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Herramientas Gage Bilt GB703SRVT/4N6E. Gage Bilt GB703SRVT/4N6E 14 páginas.

HOW TO USE THE GB703SRVT/4N6E

WARNING:

Operator

WARNING:

It is required that eye protection and hearing protection be worn during operation.

WARNING:

Do not pull rivet in the air. Personal injury from fastener ejecting may occur.

WARNING:

Air is exhausted from the bottom of the tool. Direct bottom of the tool (exhausted air) away from operator, other

persons working in the vicinity, foreign matter and liquid.

CAUTION:

Do not use beyond the design intent.

The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept end-user air

hose fitting. The tool comes with oil and is ready to use.

1. Remove plastic shipping plug from Swivel (A-249) and screw in your air fitting.

2. Connect air hose with 90 psi. (6.2 bar) to tool (3/8 minimum diameter air line is mandatory, 90 p.s.i. (6.2 bar) is recommended) and

cycle tool a few times by depressing and releasing lever assy (724017). (Clean dry air is mandatory).

WARNING:

Ensure air hose is securely connected to avoid possible hose whipping.

3. Disconnect air hose from tool.

4. Select proper Nose Assembly, screw collet and anvil onto the tool and attach securely. (See proper data sheet for further

instructions.)

5. Connect air supply.

6. Insert rivet into Nose Assembly and the application then depress lever assy (724017). Upon releasing the lever assy (724017) the

stem will eject to the rear of the tool thru the evacuation tube (703595).

WARNING:

Always disconnect air supply when tool is not in use to prevent accidental start-up.

MUST

read and understand all warnings and cautions.

Image may not reflect actual tool

11/14