Gage Bilt GB54B Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Herramienta eléctrica Gage Bilt GB54B. Gage Bilt GB54B 9 páginas. Pneumatic installation tool
También para Gage Bilt GB54B: Manual de instrucciones original (16 páginas)

Imprimir página

HOW TO USE THE GB54B

WARNING:

Operator

WARNING:

It is required that eye protection and hearing protection be worn during operation.

WARNING:

Do not pull rivet in the air. Personal injury from fastener ejecting may occur.

WARNING:

Air is exhausted from bottom of the tool. Direct bottom of the tool (exhausted air) away from operator, other

persons working in the vicinity, foreign matter and liquid.

CAUTION:

Do not use beyond design intent.

The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept end-user air

hose fitting. Air is exhausted through a port in the side of the tool. To redirect air exhaust to rear of tool, remove set screw (401816)

from rear exhaust hole. If changing exhaust back to side, we recommend applying Vibra-tite® to set screw (401816) before installation.

(see page 4 for air exhaust options.)

1. Remove plastic shipping plug from handle (510322) and install 1/4" air fitting into bottom of handle (510322). Only use an air

supply set at 90 psi-100 psi (6.2 bar-6.9 bar) equipped with a filter-regulator to prevent wear.

2. Connect air hose with 90 psi (6.2 bar) to tool (3/8" minimum diameter air line is mandatory, 90 psi (6.2 bar) is recommended) and

cycle tool a few times by depressing and releasing lever assy (551129). (Clean dry air is mandatory).

WARNING:

Ensure air hose is securely connected to avoid possible hose whipping.

3. Disconnect air hose from tool.

4. Select proper Nose Assembly, screw collet and anvil onto the tool and attach securely. (See proper data sheet for further

instructions.)

5. Connect air supply.

6. To install screw-on pulling head: While keeping internal components of pulling head forward in the nose assembly start threading

in the anvil holder, continue threading in until internal component starts to thread onto the drawbolt (541117). Thread nose

assembly in until nose assembly bottoms out. After nose assembly is completely threaded onto tool, back off nose until flat is in

the desired position and tighten locknut.

7. Insert rivet into Nose Assembly and the application then depress lever assy (551129). Upon releasing the lever assy (551129), the

stem will eject out the rear of tool.

WARNING:

Do not operate without collection bottle (A-1522) attached to tool.

8. Always hold tool so pulling head is perpendicular to surface of material in which rivet is being installed. Exert firm pressure

against rivet during installation.

WARNING:

Always disconnect air supply when tool is not in use to prevent accidental start-up.

NOSE ASSEMBLY INSTRUCTIONS

For 3/32"

only.

1. Before assembling nose assembly, insert pintail tube (40326)

into drawbolt (70342) I.D.

2. Slide until flush.

3. Install jaw assy (30314-A1) into collet (20332).

4. Screw and tighten collet (20322) to drawbolt (70342).

5. Slide pintail tube into drawbolt (541117) on tool and thread on.

6. Slide anvil and holder assy (13499) over assembled collet (20332)

and drawbolt (70342).

7. Thread and tighten anvil and holder assy (13499) to tool.

GB54B S/N: 1031 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

MUST

read and understand all warnings and cautions.

Rev. 11/15