Dawn UN7805-01 Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Mobiliario interior Dawn UN7805-01. Dawn UN7805-01 6 páginas. Vanity top mount

Imprimir página
Safety Glasses, Pencil, Level, Tape Measure, Stud Finder, Assorted Screwdrivers, Assorted Wrenches,
•
Comply with Plumbing Codes
Before installing any Dawn product in your home, you should make sure that you are in compliance with all local plumbing
codes.
•
Check Product Condition
Before installation, please check the condition of the product and, if appropriate, its components. If there is any problem
with the product and/or its components, please contact the store you purchased it from for a replacement. As soon as you
have inspected your product, please return it to its original packaging until you are ready to install it.
•
Handle with Care
To protect its finish and avoid damage before and after installation, please handle the product with care. For care and clean-
ing tips after installation, please refer to the Care and Cleaning Guide in this instruction guide.
IMPORTANT: Recommended for professional installers only. The installer maintains responsibility for installing the product safely.
1. Install the Vanity
•
Use a stud finder to locate and mark the wall studs.
•
Remove the drawer(s) from the vanity cabinet. Lift and place the vanity cabinet in position against the finished wall. Make
sure the top is level and the supply valves clear any drawers and/or shelves in the cabinet.
•
Drill pilot holes through the vanity back and the finished wall. For holes not inline with studs, push or hammer in wall anchors
that are made for your wall surface.
•
Secure the cabinet to the finished wall with screws.
2. Install the Vanity Top
•
Run a bead of silicone adhesive around the top of the vanity cabinet. Place the vanity top on top of the cabinet and press
firmly in place. Let the silicone adhesive cure.
•
Assemble the faucet and the sink drain to the vanity top.
•
Connect the water supply lines and the drain.
•
Reinstall the drawer(s).
•
Apply a bead of caulk along the back edge against the wall. Clean up any excess.
Allow 24 hours to dry.
•
Turn on the water to test for leaks.
LEGAL DISCLAIMER:
• This instruction guide is done as a public service to customers of Dawn Kitchen & Bath Products, Inc. ("Dawn"). For special situations or further assistance, please consult professionals.
• All products should be inspected by customers upon receipt and before any installation. Any defective product should be reported immediately and should NOT be installed.
• Requirements may vary for installation in a granite, marble, stone, or butcher block countertop.
• Installation by professional installers is highly recommended. Dawn assumes no liability for any damages incurred through the use of information provided in this guide.
MATERIALS & TOOLS
Drill, Screw Gun, Caulking Gun, Hammer, Screws, Nail Anchors/Molly Screws
BEFORE YOU BEGIN
INSTALLATION
3
INSTALLATION GUIDE DINA SERIES