Dawn Dawn PS510 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Sistema de altavoces Dawn Dawn PS510. Dawn Dawn PS510 4 páginas.

SATELLITES

Place the mid-high satellite speakers on stands, or mount them high enough so that the opening of the speaker is

at least as high as the tallest person likely to be in front of it. Place these speakers to the side of the performing

area and point them straight forward. You should find no increase in feedback over conventional speaker

systems, and will not need monitors or side fill speakers. You will hear exactly what your audience hears.

TROUBLE SHOOTING

FUSES

Fuses to protect the Dawn PS510 are located on the back side of the subwoofer connector plate. If one side of

the system sounds weak or distorted, it is probably due to overpowering resulting in a blown fuse. Remove the

Phillips head screws that secure the connector plate and replace the bad fuse with a T2.5 amp fuse. Be sure the

fuse is firmly seated by snapping the fuse in place. There are two fuses, one for each channel of the system.

LOW FREQUENCY FEEDBACK

This phenomena is generally caused by acoustic coupling from the floor to the microphone through the mic

stand. If possible, obtain an isolation mount for the mic.

Another solution is to place the subwoofer off stage so the mechanical vibration cannot be transmitted to the

mic stand. This will not cause much sound degradation as low frequencies are non-directional, and the sound

emanating from the subwoofer will still fill most rooms.

MIDRANGE FEEDBACK

This phenomena is generally caused by either a low-quality microphone, or speaker-room-mic placement. If

one frequency tends to feed back, change either the position of the microphone, or the distance from the mid-

high speaker to the closest wall. This will result in a different frequency being emphasized by the room and,

with several attempts, a satisfactory location can be found.

HIGH FREQUENCY FEEDBACK

This phenomena is again caused by either a low-quality microphone, or too much treble boost on the mixer.

The MI 510 has a very flat frequency response, and will produce all frequencies at the same relative volume.

Unlike conventional speaker systems, you can adjust your equalizer for a specific quality of sound, and this

sound will be presented in a uniform 180 degree pattern, rather than the very narrow 70-90 degree dispersion

offered by normal high frequency applications.

Do not overcompensate by increasing the high frequencies as with normal speaker systems.

PHYSICAL SPECIFICATIONS

Subwoofer:

Weight:

44 lbs/ 20 Kg

18"H x 17"W x 14"D

Size:

43.18cm H x 43.2cm W x 35.5cm D

Mid-High Satellite:

Weight:

2 1/2 lbs each/ 1.2 Kg each

Size:

7" H x 5 1/2" W x 5 1/2" D

17.8cm H x 14cm W x 14cm D