GAGEMAKER PNI-3003 Manual de instrucciones - Página 19

Navegue en línea o descargue pdf Manual de instrucciones para Equipamiento industrial GAGEMAKER PNI-3003. GAGEMAKER PNI-3003 20 páginas. Pin nose gages and seal diameter gages pin nose gages and seal gage operation manual

Imprimir página

Pin Nose Gages and Seal Gage Operation Manual

GAGE OPERATION

Slider

Block

Slider

Knob

Record Deviation

Tapered Seal

Connector

Sweep Gage to

Locate Largest Indicator

Reading

Round

Setting

Standard

The following diagrams display the proper setup

and operation of the PN-3000 Pin Seal Diameter

Gage.

1. Adjust the lower block of the PN-3000 gage to

a location that the contact points or Anvil fit

around the seal diameter of the setting standard.

2. Continue to adjust the lower block position

until adequate preload of the indicator has been

achieved. Lock the lower block lock knob. Normal

preload is approximately 1/2 - 1 revolution.

3. Sweep the gage to locate the largest indicator

reading (the point a which the indicator needle

changes direction). When the largest diameter is

located, rotate the indicator bezel to align the

zero with the needle. Tighten the indicator bezel

clamp.

4. Remove the gage from the standard and

place the gage against the connector face.

5. Using the lower (fixed) contact point or Anvil

as a pivot, sweep to locate the largest reading.

6. When the largest reading has been located,

record the deviation from zero on the proper

inspection report form.

Tapered

Seal

Zero

Indicator

Surface