Great Circle LCE01 Manual de instrucciones - Página 13
Navegue en línea o descargue pdf Manual de instrucciones para Trituradora de papel Great Circle LCE01. Great Circle LCE01 18 páginas. Chipper shredder
Imprimir página
REPAIR
Shredding Hammer Rotation and Replacement
The cutting edges of the shredding hammers may eventually wear out requiring rotation of the hammer or replace-
ment if all cutting edges have been dulled.
To rotate the shredding hammers:
1. Turn the engine off and wait for all moving parts to stop.
2. Disconnect the spark plug wire and secure it away from the spark plug.
3. Detach the rotor housing and hopper from the rotor plate. SEE FIGURE 9
4. Note the assembly sequence of the hardware used to secure the hammers. Using an allen wrench remove the
socket head cap screw (A) and related hardware. SEE FIGURE 10
5. Inspect the hammers (D), spacer tubes (C, E), and hardware. If the spacer tube (E) shows signs of wear, replace
it. Inspect and flip, or replace the hammers (D).
6. Reassemble the hammers, spacers, washers, and cap screws.
Torque the socket head cap screws (A) back tightly
7. Repeat for all the hammers.
Chipping Knives Sharpening and Replacement
1. The chipping knives should be sharpened or replaced when tree limbs require extra force to feed into the chipper cone.
2. The chipping knives may be sharpened at a 39 degree angle until the distance between the edge of the blade
bevel and the mounting hole is less than 1/16" (1.6mm). SEE FIGURE 13.
To inspect, sharpen, or replace the chipping knives:
1. Turn the engine off and wait for all moving parts to stop.
2. Disconnect the spark plug wire and secure it away from the spark plug.
3. Detach the rotor housing and hopper from the rotor plate. SEE FIGURE 9
4. Remove the rotor by removing the hardware that secures it to the engine
crank shaft. SEE FIGURE 11. NOTE: Do not lose spacer. During
reassembly Be sure to place spacer is installed inside rotor.
Without spacer, rotor will interfere with housing components.
5. Using a hex wrench, remove the two socket head cap screws
and the chipper knife. SEE FIGURE 12
6. Inspect, rotate, sharpen, or replace the chipper knife. SEE FIGURE 13
7. Reinstall the chipper knife and tighten the socket
head cap screws
Figure 13- Chipper knife minimum cutting edge
Figure 9
Figure 10
Crank shaft
Spacer
Figure 11
Chipper kinfe
Figure 12
11