Dawson MULCH MATE DS1000 Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Césped y jardinería Dawson MULCH MATE DS1000. Dawson MULCH MATE DS1000 14 páginas. Mulch delivery system

Imprimir página

Using Unit on Site

● Turn the power to the machine on. (Follow start up

procedures pg. 9)

● Roll up chute door cover and slide back the chute exit tray.

● Place wheel barrow under the exit chute.

● Press and hold the joystick in the "down" position. This will

run both the tarp and the conveyor at the same time. The

tarp is on a 2 second on/off delay so keep holding until

mulch starts to run through the machine. When the

wheelbarrow is halfway full, push joystick "up" to just run

the conveyor belt. This helps prevent the belt from

overloading with too much mulch.

● The power may be left on while running mulch, but care must be taken to ensure no unauthorized

persons have access to the machine when unattended.

● When refilling your wheelbarrow, just press the joystick to the "down" position to refill and Top Off.

● Occasionally you must clear the conveyor belt of built up mulch by pressing the joystick to the

"up" position. This will run the conveyor by itself clearing the belt of any built-up mulch.

Opening Unit to Load Debris

You may load debris behind the tarp, in the space between the tarp and the truck, after a partial load of mulch

has been dispensed. Or once the truck has been emptied of mulch, you may swing the machine away and

secure it the driver side of the truck. This will allow you to load debris back into your truck for removal.

● Press joystick to the up position to run only the conveyor motor to clear the conveyor belt.

● After all of the mulch has been emptied from the truck . Press

the joystick to the "left" position to run only the tarp motor to

roll up the remaining tarp.

● Make sure the area around the machine is clear, r elease the

hinge locks .

● It is recommended that swinging the unit should be a two

person operation.

● Release the passenger side latch lock, pull down on the handle

to release the machine.

● Always keep control of the machine when it is unlatched.

● Walk the unit around to the driver side of the truck and secure

the hinge locks and the secondary safety chain to ensure the

machine is properly locked in place. Be sure to secure the

safety chain in the hole in located at the upper left corner of the chute hole. DO NOT ATTACH TO THE

HANDLE.

● You may now load debris into your truck for transport.

Operations