Dawson Tools DDM350 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Multímetro Dawson Tools DDM350. Dawson Tools DDM350 12 páginas.

Imprimir página

Resistance Measurement

Warning
To avoid electrical shock and injury, power off the
circuit and discharge the capacitance before
measuring resistance.
• Insert the black test lead or lead with test clip in the
"COM" jack.
• Set the rotary switch to the " " position. Manual range
can be chosen by pressing the "RAN" button. Hold
"RAN" to go back to Auto range.
• Connect the probe tip of the meter and tip of the test
lead (or test clip) across the resistance or circuit under
measurement and read the measured value on the
display.
NOTE:
•
The meter may take a few seconds to reach steady
reading if the measured resistance is above 1MΩ.
• When the input is not connected (i.e. an open circuit)
"OL" will be displayed.

Diode Test

•
Insert the black test lead or test clip in the "COM" jack.
• Set the rotary switch to the "
to choose diode measurement; "
• Connect the probe tip of the meter and tip of the test
lead (or test clip) across the diode under measurement
and read the measured value on the display.
NOTE:
The Meter shows the forward voltage drop. If the lead
connection is reversed, "OL" is displayed.
Ω
"position. Press "FUNC"
"is displayed.
09

Capacitance Measurement

Warning
To avoid electrical shock and injury, power off the
circuit and discharge the capacitance before
measuring capacitacne.
• Insert the black test lead or lead with test clip in the
"COM" jack.
• Set the rotary switch to the "
• position.Press "FUNC" twice to choose capacitance
measurement.There is no manual range available in
capacitance mode.
• Connect the probe tip of the meter and tip of the test lead
(or test clip) across the capacitance or circuit under
measurement and read the measured value on the
display.
NOTE:
The meter may take a few seconds to reach steadyeading
when making high capacitance measurements.

Continuity

Warning
To avoid electrical shock and injury power off the
circuit and discharge the capacitance before
measuring continuity.
•
Insert the black test lead or lead with test clip in the
"COM" jack.
• Set the rotary switch to the "
3 times to choose continuity test; "
• Connect leads to the circuit terminals.
• If continuity exists (i.e. resistance is less than 50Ω), the
built-in buzzer will sound.
"
"position. Press "FUNC"
"is displayed.
10