DAX BATHTUB FILLERS DAX-8129 Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Sanitarios DAX BATHTUB FILLERS DAX-8129. DAX BATHTUB FILLERS DAX-8129 4 páginas.

Imprimir página
Figure 1
Cold water inlet
Figure 2
Handshower
M5 Screw
Shower holder
Hose
Flange
Finished floor
I N S TA L L AT ION G UID E
Installation steps
Cylindrical screw
1.
Flange
Plug
Inlet base
2.
Hot water inlet
Expansion bolt
3.
4.
5.
Faucet body
Shower holder joint
6.
7.
Set screw
Inner pipe
Escutcheon
8.
9.
Cylindrical screw
10. Connect handshower and shower holder with hose,run water
ww w. daxib.c
As shown in Fig.1, take 4 mounting holes on inlet base as
benchmark to drill holes on the floor (Note: ensure hot water
inlet which printed with "HOT" faces to the bathtub). Fix inlet
base on the floor with expansion bolt.
Pave cold and hot water inlet pipes on the floor and connect
to the inlet base. (Note: "HOT" mark for hot water inlet,
"COLD" mark for cold water inlet).
Insert plug into outlet of inlet base and tighten it with flange
(Note to keep the side with counter bore of flange face
upward), run water and keep pressure for 2 hours test, ensure
each joint has no leakage occurs. Note: as the product is a
built-in valve, do test it well and ensure no leakage before
paving floor tiles.
Remove flange and plug.
Put on protection sheath for paving floor tiles (Note: the
height of tiles should be at the same level or a bit higher
than the top surface of inlet base. Make edge of tiles along
protection sheath for a better appearance).
As shown in Fig.2, put on escutcheon to faucet body carefully
to avoid scratch to the surface of faucet body.
Remove protection sheath from inlet base and inner pipe,
pass flange (keep the side with counter bore back against
faucet body) through inner pipe and fix to faucet body firmly
with cylindrical screws,insert inner pipe into the outlet of inlet
base, connect flange and inlet base with cylindrical screws
and fix by allen key.
Close escutcheon to floor tiles.
Fix shower holder to shower holder joint and tighten with set
screw (Note to aim M5 screw on faucet body at the hole of
shower holder).
to check if the installation is qualified.
om
D A X- 81 2 9