Aircommand Heron Q Manual del mando a distancia - Página 2
Navegue en línea o descargue pdf Manual del mando a distancia para Aire acondicionado Aircommand Heron Q. Aircommand Heron Q 2 páginas. Reverse cycle split system air conditioner for caravans & motorhomes
También para Aircommand Heron Q: Manual de instrucciones de instalación (17 páginas)
Imprimir página
If Cooling is required, press Mode button until "COOL" appears on top left on display.
Adjust the desired temperature using the Temp ▲ or ▼ buttons .
The red power indicator on the facia is alight but the green compressor running light will not come
on for 3 minutes. The fan will start immediately.
You may choose Hi, Med, or Lo fan speed by pressing FAN button . If you choose AUTO, then
the unit will change fan speed depending on the relation between thermostat setting and actual
temperature of the return air.
If you wish to use the unit as a dehumidifier only, then use the Mode button to select "DRY".
The fan speed becomes auto only and the control will cycle the fan and compressor at 6 minute
intervals to achieve maximum dehumidification.
The "ECONO COOL" button when pressed will automatically change the thermostat to maintain
25°C. This will make the unit far more economical to use than at a lower temperature.
By pressing the "SLEEP" button , if in cooling mode the thermostat will automatically raise the
set temperature by 1°C after an hour of operation.
By pressing the "SLEEP" button in heat mode, the thermostat will automatically lower the
temperature by 1°C after an hour of operation.
This facility allows better running economy as the sleeping occupants do not require the same
comfort setting.
The "SEND" button resend all the handpiece settings to the control. If one is unsure that the unit
received the handpiece settings, (handpiece may not have been pointing at the facia when adjusting
settings) this allows all settings to be retransmitted together.
Please note that the "LOUVRE" and "SWING" functions are not enabled on the Heron Q.
❖ To set the unit to automatically start from 10 minutes to 24 hours into the future.
With the unit Power on.
Press "START" button . The on time display will flash in the bottom left corner of display.
Use the HR & MIN buttons to set the time you wish the unit to start.
Now press the ON/OFF button to turn off the unit.
If you wish to cancel this function then press "START" button again.
❖ To set the unit to automatically stop from 10 minutes to 24 hours into the future.
With the unit Power off.
Press "STOP" button .
The off time will flash in the lower display.
Use the HR & MIN buttons to set the time for unit to stop.
Now press the ON/OFF button to restart unit.
You may cancel this function by pressing the "STOP" button again.
If the batteries in the handpiece are flat and replacements are not immediately available or the
handpiece is lost or misplaced, then the unit may be turned on by pressing the ON/OFF button
on the facia. The unit will operate on the last settings put in. e.g. If last setting were HEAT and
thermostat setting was 24°C then the unit will remember this and continue to heat with a set point of
24°C. No change can be made until the handpiece is made operational or replaced.
HERON Q
Operation Instruction
A.B.N. 79 007 592 234
AIRCOMMAND AUSTRALIA PTY LTD
954 Port Road, Albert Park
South Australia 5014
AUSTRALIA
Phone: (08) 8445 2877
Fax: (08) 8243 0628
www.aircommand.com.au