Agrident AIR300 Manual de hardware - Página 4

Navegue en línea o descargue pdf Manual de hardware para Escáner Agrident AIR300. Agrident AIR300 12 páginas. For motorola workabout pro-g4

AIR300 Hardware Manual for WAPro-G4

Introduction

The Agrident Integrated Reader 300 (AIR300) is a Low Frequency RFID reader working on

134.2KHz, which is designed for the Motorola Workabout Pro - generation 4. It is backwards

compatible to the generations 2 and 3. Since this reader is using the internal USB port for power

supply and communication, it cannot be used with generation 1 of the Workabout Pro, which

does not have an internal USB connector.

Mechanically the AIR300 is using the expansion end cap of the Workabout Pro. That means

that it is physically not possible to operate the reader together with other expansion modules

that are using the extended end cap position.

For all approval and safety information concerning the WORKABOUT Pro Generation 4please

visit

www.motorola.com

The following installation instructions refer to the WORKABOUT PRO G4 – short version. The

instructions and pictures might vary for the long version and for other generations of the

Workabout Pro. Please also see the corresponding Workabout Pro documents for details.

Currently the manuals for all generations of the WORKABOUT PRO are available for download

here:

http://community.psion.com/knowledge/w/knowledgebase/562.workabout-pro-product-

manuals.aspx

Before installing a module in the WORKABOUT PRO G4, all power sources must be turned off.

If your unit is using AC power, disconnect it. Now remove the battery cover and the battery.

With the power shut down, you can install the RFID Module AIR300.

26/02/15

or contact your local Motorola distributor.

Page 4 of 12