Hi-Force TWM1000 Series Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Herramientas Hi-Force TWM1000 Series. Hi-Force TWM1000 Series 5 páginas.
Imprimir páginaAccessory parts not approved by the
manufacturer may overload.
ALWAYS inspect the torque wrench for
damage BEFORE every use.
NEVER use a damaged torque wrench.
NEVER use the torque wrench if it has been
dropped, used to strike other objects, or if
anything has fallen on it.
ALWAYS IMMEDIATELY release the torque
wrench after you hear the click indicating that
you have reached the desired torque setting.
DO NOT continue to tighten the bolt after you
hear the click!
INACCURATE TORQUE SETTINGS
An out-of-calibration torque wrench can cause
part or tool breakage and inaccurate torque
settings,
ALWAYS use tested and calibrated torque
wrenches only. ALWAYS use an approved
torque tester.
Safety Precautions
Take the following safety precautions to
prevent injuries and damage when using the
torque wrench:
ALWAYS use only original accessory
parts or parts approved by the
manufacturer.
ALWAYS check the torque wrench for
the proper torque setting prior to
tightening every bolt.
ALWAYS position the torque wrench
and socket extensions at a 90° angle.
Use ratchet adapters when working in
tight work areas. Reverse the torque
wrench without removing it.
When using ratchet adapters, e.g. for
deep seated bolt positions, ALWAYS
hold them for as short a time as
possible.
If the resistance changes
unexpectedly while tightening a bolt,
release the torque wrench
immediately. Check the torque
wrench and the bolt for damage.
NEVER use reducers with the torque
wrench. Reducers will not bear the
load of the forces created when using
the torque wrench.
Only turn the torque wrench in the
direction of the arrow on the housing
of the torque wrench.
When using non-standard extension
end fittings, always hold the torque
wrench tool in the center of the
handle.
Hi-Force Limited – Prospect Way – Daventry – Northants NN11 8PL – United Kingdom
Tel: +44(0) 1327 301000: Fax: +44(0) 1327 706555: Website: www.hi-force.com
INSTRUCTION MANUAL:
Model Series: TWM1000, TWM1500, TWM2000
Tightening Bolts:
1) ALWAYS check the
bolt for damage
and excessive
wear.
2) ALWAYS determine
the width of the bolt
head before tightening the bolt.
3) ALWAYS select the appropriate socket
according to the width of the bolt.
4) Attach the socket
(or other accessory)
to the torque
wrench's square
drive.
5) Make sure the connection between
the ratchet head and the socket (or
accessory) is secure by gently pulling
on it.
6) Place the torque wrench (H) with the
attached socket onto the bolt at a
90° angle.
7)Turn the torque wrench by the handle
(B) slowly and steadily in the direction of
the arrow indicated on the housing until
you hear a click and feel a slight jerk of
the handle.
IMMEDIATELY release the torque wrench after
you hear the click indicating that you have
reached the desired torque setting. DO NOT
continue to tighten the bolt after you hear the
click!