Gaggenau VG 295 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Placa de cocción Gaggenau VG 295. Gaggenau VG 295 16 páginas.

Imprimir página

Operation

The markings show the position of the corresponding

burner and the setting between high and low heat. The

flame setting is infinitely variable between high and low

heat.

Notes

‒

Only light a burner if all pan supports and burner

parts are properly assembled.

‒

Make sure the burners and electrodes are clean

and dry.

‒

Only use the recommended accessories. Do not

cover the stainless steel cooktop base (e.g. with

aluminium foil).

‒

Do not cover the air inlet at the back of the cooktop.

Caution!

Heat damage to the extractor hood: Always switch on

the extractor hood while the gas cooktop is in use.

When using several cooking positions select a higher

fan level on the extractor hood. Make sure there is a

sufficient ventilation of the room.

Switching on

Your cooktop features automatic fast ignition.

Place a suitable pot or pan on the corresponding

cooking position.

Press down the corresponding control knob and

turn it anticlockwise to the required position. The

burner lights automatically.

The flame size can be set continuously between high

and low by slowly turning the control knob.

Notes

‒

When using large pots or pans you should ignite

the burner in the low position.

‒

Every time the gas hob is switched on, the

electronics run an auto test. All electrodes fire and

the required burner ignites after a few seconds.

When switching on further burners, only the

corresponding electrode fires.

‒

When being switched on, a short sound may be

heard when the electronic of the gas hob opens the

gas supply valve. This is a normal condition.

‒

The cooktop cannot be used during a power failure.

Operation indicator

The operation indicator next to the control knob comes

on, if the burner is switched on and the flame burns

correctly. If a malfunction occurs the operation indicator

will flash.

Electronic flame detection and

automatic re-ignition

For your safety the cooktop features electronic flame

monitoring. Should the flame go out during operation

(e.g. because of a draught), the appliance will

automatically re-ignite the burner.

Should the re-ignition be unsuccessful (e.g. burner is

soiled by spilled over food or liquid), all burners are

switched off, the indicator lights of the burners that

were switched on flash.

Turn all control knobs to the OFF position. The flashing

indicator lights will go out except for the affected

burner. This indicator will continue to flash for a few

seconds.

After the appliance has cooled down sufficiently, check

this burner to see if all the burner parts have been

assembled correctly. Check if the burner or the

electrode has been soiled (see trouble shooting guide).

Note: If a malfunction occurs on one burner, you can

continue using the remaining burners, however, you

must turn all control knobs to the off-position first,

before recommencing.

Please note when switching on the cold appliance on

the HIGH setting:

Depending on the gas type and pressure, it is possible

that the electrode continues to fire, although there is a

flame visible, and then switches off. Turn all control

knobs to the OFF position. Then turn the control knob

for the required cooking position to any setting except

the high position and leave to warm up for 30 to

60 seconds. Then you can continue to use your

appliance as usual.

Switching off

Turn the corresponding control knob clockwise to the

OFF position.

The electronics of the appliance will switch the gas

supply off, if all control knobs are in the off position.