Gaggenau CG261210AU Instrucciones de uso - Página 7

Navegue en línea o descargue pdf Instrucciones de uso para Placa Gaggenau CG261210AU. Gaggenau CG261210AU 20 páginas.

A duplicate data label is supplied for adhesion to an

accessible location near the hotplate if the data label on

the base of the hotplate cannot be accessed when the

hotplate is installed.

Clearances

A range hood fitted above the top must be installed

according to the installation instructions for the range

hood. A minimum distance of 650 mm is required for a

range hood and 750 mm for an exhaust fan.

Installation and connection

Any adjoining wall surface situated within 200 mm from

the edge of any hob burner must be a suitable non-

combustible material for a height of 150 mm for the

entire length of the hob. Any combustible construction

above the hotplate must be at least 650 mm above the

top of the burner and no construction shall be within

450 mm above the top of the burner.

A minimum depth of 50 mm from the top of the worktop

surface must be provided for the appliance.

If the base of the hotplate can be touched, a protecting

shield must be fitted.

▯

The shield must be at least 10 mm from the lowest

part of the hotplate and must be capable of

withstanding the appliance temperatures. Minimum

thickness of benchtop is 30 mm.

▯

The shield material must be mdf or similar with

minimum thickness of 12 mm.

▯

The shield overall dimensions must be 560 mm wide

x 480 mm deep.

▯

Provide cut-out in right hand rear of shield of

80 mm wide x 80 mm deep to provide for gas

regulator / LP connection fitting.

After installation of the shield the clearance around the

top and sides of shield will allow adequate ventilation.

Ensure the side and top clearances are not obstructed.

If an oven is positioned below the cooktop the barrier

does not need to be fitted, but a space of 35 mm must

be maintained between the underside of the cooktop

and the top of the oven.