70mai X200 Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Cámaras de salpicadero 70mai X200. 70mai X200 7 páginas.
Imprimir página
Installation
1. Installing the electrostatic
sticker
Put the electrostatic sticker
on the recommended area as
shown in the figure. Make the
gap on the electrostatic sticker
face upwards.
Select the flat, smooth and clean area for the installation
and avoid the edge of the windshield. Remove air bubbles
between the sticker and the glass.
2. Installing the dash cam
Peel off the protective film from the
adhesive sticker and paste the dash cam
on the electrostatic sticker in the dotted
area.
Make sure the gap on the adhesive sticker
aligns with that on the electrostatic sticker and the display
screen faces the car interior.
3. Connecting the power
supply
Run the power cord along the
top of the windshield, down the
A-pillar, and around the glove
compartment. Connect the power cord to the car charger,
then plug the charger into the cigarette lighter socket.
Notes:
Use the included crowbar to hide the power cord
●
underneath the vehicle's headliner and rubber seal
along the A-pillar.
Depending on the vehicle, the cigarette lighter socket
●
may be located in a different position. The figure
provided is for reference only.
4. Adjusting the dash cam angle
Hold the dash cam and turn the dash
cam up and down to adjust the dash
cam angle based on the preview
screen.
Installing/uninstalling the mount
The mount is pre-installed on the dash cam. If you need to
unstall it, follow the steps below:
Uninstalling the
mount:
Hold the
dash cam and screw it
clockwise and then the
dash cam will seperate
with the dash cam.
02