GREAT PLAINS 1205 Manual de ajuste de campo - Página 4
Navegue en línea o descargue pdf Manual de ajuste de campo para Maquinaria agrícola GREAT PLAINS 1205. GREAT PLAINS 1205 5 páginas. End wheel no-till drill
Imprimir páginaT-Handle Adjustment:
The depth of each opener is controlled by the height of
the press wheel. Varying the height of the press wheel
changes the seeding depth of the opener. Moving the "T"
handle to the front of the opener shallows the depth;
moving the "T" handle towards the rear of the opener
increases the depth. For a starting point, place the "T"
handle in the center.
Gauge Wheel Idler Adjustment:
Located inside the left hand gauge wheel arm is two idler
sprockets that should be readjusted after the first 100
acres of drill use. From then on, readjust the idler sprock-
ets at the beginning of each season.
tighten the chains to avoid excessive wear.
Seed Cup Adjustment:
Check all seed cups to ensure that they are clean and
free of obstructions. The seed rate handle should move
freely and not have excessive play in it.
1) To check seed cups for accuracy, loosen the seed
adjustment handle by unscrewing the wing nut located on
the underside of the handle and sliding the seed box rate
handle to 100.
2) Place a seed calibration tool (817-459C) into the seed
cup from the top (use the 7/8" side).
3) Once the tool has been placed into the seed cup, slide
the seed adjustment handle until the feed wheel presses
up against the block tightly.
4) With the feed wheel pressed tightly against the calibra-
tion tool, the seed cups are set at exactly 50%. The brass
gauge should read 50%. If the seed adjustment handle is
not lined up on 50%, loosen the two screws holding the
gauge and adjust the brass plate until it reads 50% then
tighten the screws.
Document
#DRUS500C-0002A
48642
Note: Do not over-
48712
48381
48380
4 of 5
Deeper
Shallower