Gaggenau VP230120 Manual del usuario - Página 11
Navegue en línea o descargue pdf Manual del usuario para Placa Gaggenau VP230120. Gaggenau VP230120 16 páginas.
Imprimir página
It must always be possible to disconnect the appliance
from the electricity supply. The appliance must only be
connected to a protective contact socket that has been
correctly installed.
The mains plug of the mains power cable must be
▶
easily accessible after installation of the appliance.
If this is not possible, an all-pole isolating switch
▶
must be integrated into the permanent electrical in-
stallation according to the conditions of overvoltage
category III and according to the installation regula-
tions.
The permanent electrical installation must only be
▶
wired by a professional electrician. We recommend
installing a residual-current circuit breaker (RCCB)
in the appliance's power supply circuit.
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
WARNING ‒ Risk of electric shock!
Incorrect installation is dangerous.
Connect and operate the appliance only in accord-
▶
ance with the specifications on the rating plate.
Connect the appliance to a power supply with al-
▶
ternating current only via a properly installed socket
with earthing.
The protective conductor system of the domestic
▶
electrical installation must be properly installed.
Never equip the appliance with an external switch-
▶
ing device, e.g. a timer or remote control.
When the appliance is installed, the mains plug of
▶
the power cord must be freely accessible. If free ac-
cess is not possible, an isolating switch must be in-
tegrated into the permanent electrical installation ac-
cording to the installation regulations.
When installing the appliance, check that the power
▶
cable is not trapped or damaged.
13.6 Information about the installation room
For safe operation, observe the following information
regarding the installation area.
¡ Install the appliance in accordance with the installa-
tion diagram.
¡ Ensure that the wall behind the appliance is made
of non-combustible material.
13.7 Installation accessories
Here, you can find an overview of the installation ac-
cessories.
Use the accessories only as specified. The manufac-
turer shall accept no liability if you use the accessories
incorrectly.
Accessories
Appliance cover, black
Connecting strip, stain-
less steel
Connecting strip, black
Order number
VD200020
VV200010
VV200020
13.8 Combining multiple appliances
Requirement: You need a suitable connection strip to
combine several Vario appliances. You can obtain the
connection strip as an optional accessory.
When making the unit cut-out, allow extra space for
1.
the connecting strip between the appliances.
Observe the installation instructions for the con-
‒
nection strip.
If required, install the appliances in individual cut-
2.
outs.
Maintain a bar width of at least 40 mm between
‒
the individual cut-outs.
13.9 Installing the appliance cover
You can obtain a suitable appliance cover as an op-
tional accessory.
Secure the appliance cover to the appliance before
▶
installing it.
Follow the installation instructions for the appli-
‒
ance cover.
13.10 Preparing the unit
Requirements
¡ The fitted units are heat-resistant up to 90 °C.
¡ The worktop is level, horizontal and stable.
Follow the instructions on combining several appli-
1.
ances.
→ "Combining multiple appliances", Page 11
Ensure that the stability of the fitted unit is guaran-
2.
teed after the cut-outs have been made.
Ensure that the thickness of the worktop corres-
3.
ponds to the required minimum thickness.
Installation instructions en
11