Dynabrade 52864 Manual - Página 3

Navegue en línea o descargue pdf Manual para Amoladora Dynabrade 52864. Dynabrade 52864 8 páginas. 25,000 rpm pencil grinder

Imprimir página

Handling and Storage:

• Protect abrasive accessories from exposure to water, solvents, high humidity, freezing temperature and extreme temperature changes.

• Store accessories in protective racks or compartments to prevent damage.

Filter

Regulator

90 PSIG

(6.2 Bar)

• Dynabrade Air Power Tools are designed to

operate at 90 PSIG (6.2 Bar/620 kPa) maximum

air pressure at the tool inlet, when the tool is

running. Use recommended regulator to control

air pressure at each work station, if the supply

pressure is high.

• Ideally the air supply should be free from

moisture. To facilitate removing moisture

from air supply, the installation of a

refrigerated air dryer after the compressor

and the use of drain valves at each

tool station is recommended.

All Dynabrade motors use the highest quality parts and metals available and are machined to exacting tolerances. The failure of quality pneumatic motors can

most often be traced to an unclean air supply. Air pressure easily forces dirt or water contained in the air supply into motor bearings causing early failure. Dirt

and water often score the inner workings of the tool resulting in limited efficiency and power. Our warranty obligation is contingent upon proper use of our

tools and cannot apply to equipment which has been subjected to misuse such as unclean air, wet air or a lack of maintenance during the use of this tool.

All Dynabrade portable pneumatic power tools are rigorously inspected and performance tested in our factory before shipping to our customers. If

a Dynabrade tool develops a performance problem and an inherent defect is found during normal use and service, Dynabrade will warrant this tool

against defects in workmanship and materials for the lifetime of the tool. Upon examination and review at our factory, Dynabrade shall confirm that

the tool qualifies for warranty status, and will repair or replace the tool at no charge to the customer. Normally wearable parts and products are

NOT covered under this warranty. Uncovered items include bearings, contact wheels, rotor blades, regulators, valve stems, levers, shrouds,

guards, O-rings, seals, gaskets and other wearable parts. Dynabrade's warranty policy is contingent upon proper use of our tools in accordance

with factory recommendations, instructions and safety practices. It shall not apply to equipment that has been subjected to misuse, negligence,

accident or tampering in any way so as to affect its normal performance. To activate lifetime warranty, customer must register each tool at

www.dynabrade.com. Dynabrade will not honor lifetime warranty on unregistered tools. A one-year warranty will be honored on all unregistered

portable pneumatic power tools. Lifetime warranty applies only to portable pneumatic tools manufactured by Dynabrade, Inc. in the USA. Lifetime

warranty applies only to the original tool owner; warranty is non-transferable.

MAINTENANCE INSTRUCTIONS - CONTINUED

Air System

Lubricator

Closed Loop Pipe System

To Tool Station

Ball

Valve

Drain

Valve

PSIG at Air Tool

90 PSIG MAX

Notice

Lifetime Warranty

Regulator

Filter

Lubricator

➤

Drain

Air Hose

Valve

Drain

(6.2 Bar)

Valve

LUBRICATOR SETTING

1 DROP/MIN.

20 SCFM

Air Flow

Refrigerated

Air Dryer

Ball

Valve

Air Flow

Air Compressor

and Receiver