Hi-Tech Diamond All-U-Need Glass/Crystal Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Sander Hi-Tech Diamond All-U-Need Glass/Crystal. Hi-Tech Diamond All-U-Need Glass/Crystal 16 páginas.

Imprimir página

OPERATING INSTRUCTIONS

1
Carefully unpack the All-U-Need from the box
and remove all loose foam and accessories.
Set the packaging aside should you need it in the
future. Check to make sure all parts are present
on both the machine and in the accessory kit. If
you find any missing or damaged parts, call us
immediately at 1 (630) 596-9909 or email us at
2
Place the All-U-Need on a table or surface
that is flat in a well lit location. Make sure
the machine sits level and the white catch tray
is securely mounted on a horizontal plane on
the motor housing. If the tray is raised or tilted,
it will hit the motor shaft or silver arbor and rub,
causing a squeaking sound on the arbor.
3
Install the water system by inserting the black
tube with valve into the white cup with the
hole. Position this cup on top of the spray shield.
Insert the clear drain tube into the drain hole
on the bottom right side of the white catch tray.
Position the other white cup under the drain tube.
See cover image for correct set-up. Fill the top
cup with clean water. Never re-use water. Note: To
install the optional cup holder or Pro-Flow water
cooling system, see page 11.
4
Included in the All-U-Need accessory kit are
three colored diamond smoothing discs, one
Tech-11 polishing pad and four backing plates.
The smoothing discs and Tech-11 pad need to
be assembled before use. To do this, remove
the protective backing from the discs and apply
the pressure-sensitive adhesive side to a clean,
smooth surface of the backing plate. Each disc
needs a backing plate. Make sure to center the
pre-punched hole in the disc with the arbor hole
in the backing plate. Improper centering may
cause the disc to spin out of round resulting in
machine vibration. Make sure the discs have even
contact with the backing plate surface.
Note: Discs may be slightly smaller than the
backing plates.
5
Put the 180# diamond lap disc on the arbor
and secure with the ¼"-20 thread knurled
black knob and washer (Fig. A). This is the first
disc you will use to start shaping your rough
material. Put on safety goggles (not included)
and turn the power switch on. Adjust the water
drip so that the water is aimed at the center of
the disc. You only need a few drops of water to
adequately lubricate the discs. You can control
the splash by raising or lowering the black spray
shield.
Silver arbor
with washer
White catch
tray
Screws (4)
located on
the black
spray shield
are adjustable
to raise and
lower the
spray shield
to control the
water splash
Fig. A
7