Hi-Tech Diamond SLANT CABBER Instrucciones de uso - Página 3

Navegue en línea o descargue pdf Instrucciones de uso para Sander Hi-Tech Diamond SLANT CABBER. Hi-Tech Diamond SLANT CABBER 3 páginas.

OPERATING INSTRUCTIONS FOR SLANT CABBER

Cleaning and Storing the Machine:

1. Turn off the machine leaving the water on. Using a brush, clean the disc, turn off the water and

turn on the machine to spin the disc completely dry. Remove the dry disc from the machine and

place in its clean, dry plastic bag.

2. Unplug the machine before cleaning it.

3. Turn the water feed on to drain the water supply reservoir. Use a sponge and bucket to soak up

any remaining water in the water supply reservoir.

4. Remove the disc shield and wash and dry it.

5. Wash the machine and flush out the waste water reservoir with clean water. Flush out the

waste water reservoir by taking a small bucket of water and pouring the water into the bottom

reservoir so all the sediment will get flushed down the drain tube. Once you see all the sediment

gone, you can move on to the next step. (Note: Monitor the waste bucket to make sure you do

not overflow it while flushing out the slant cabber.)

6. On the newer model use the short piece of tubing to blow out the water feed tube. This is to

prevent the water from calcifying in the tube and plugging it up.

7. Dry the machine with paper towels.

8. On the older model pull out the drain tube and coil it in where the disc is normally mounted.

Coil the electrical cord and place it in the machine. Place the disc shield loosely on top of the

cord and waste tube. On the newer model do not pull out the drain tube just coil it in the disc

shield.

9. Carry the cleaned machine and box of discs to the rolling cart and place it on the middle shelf.

10. Dispose of the dirty waste water outside (never down the sink).

11. Wipe the tablecloth, fold and put it in the storage room.

12. Wipe up any water on the table and floor including any water on your path to the door.

Created 03/29/2016, Revised 11/01/2017

The Villages® Gem & Mineral Society

Page 3 of 3