HI-VAL 3 1/2" 1.44MB Floppy Disk Drive Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Unidad de disquetes HI-VAL 3 1/2" 1.44MB Floppy Disk Drive. HI-VAL 3 1/2" 1.44MB Floppy Disk Drive 6 páginas. 1.44mb
Imprimir páginaTroubleShooting
Symptom
Indicator light never turns on when executing READ or
WRITE to floppy
Indicator light comes on as soon as power is applied and
stays on
Drive type mismatch during boot
Invalid media or Track 00 bad when formatting.
The same directory is displayed for different diskettes.
Drive not ready error reading drive X.
General Failure reading Drive X.
Sector not found error
Page 4
1.44 Floppy Drive
Solution
Make sure that the interface cable and power cable is properly
connected.
The ribbon cable may be reversed. Check Pin #1 orientation.
Check CMOS setup for correct drive type. If the indicator light comes
on, check for head recalibration to Track 00; if it doesn't, drive may
be malfunctioning.
Attempting to format an HD diskette to 720K or DD diskette to
1.44MB. Drive is not properly set in CMOS setup, or controller card is
not configured correctly. Check setup by referring to controller
documentation.
Controller card is not receiving a disk change signal. Check the drive
for the correct strap setting. Pin #34 on the ribbon cable may be
broken, or the disk drive is malfunctioning.
No diskette is insertedd in the drive or the motor is not spinning.
Drive may need service.
Diskette not formatted. Drive out of alignment. DSDD disk formatted
to 1.44MB HD disk formatted for 720K. Use correct disk.
Head seek error or drive out of alignment.
User's Guide