DYNACO PAT5PWR Manual de montaje - Página 10

Navegue en línea o descargue pdf Manual de montaje para Amplificador DYNACO PAT5PWR. DYNACO PAT5PWR 18 páginas. Replacement power supply rev e hardware

Imprimir página

It's good practice to keep the bottom heatsink straight so that it doesn't touch the near-by

trace. It's actually not a problem if it does touch it, since the two nets are connected

Figure 7).

Figure 7-Line up the bottom heatsink to not touch the nearby trace

Install the Small Non-polar Capacitors

Designation Description

0.01 µF, 400 Volt film capacitor, box capacitor

Install Shunt Regulator and Small Transistor

Be very careful. The shunt regulator and small transistor come in the same type of

package, known as a TO-92. They sit right next to each other on the PCB. However,

their functions are very different. Make sure to read the writing on the packages to get

the right device in the right place.

Designation Value

TL431

2N5401 High Voltage PNP transistor, TO-92 package, look

Install the Electrolytic (polarized) Capacitors

Polarized Capacitors (watch polarity and voltage rating)

Designation Value

100 µF

10 µF

470 µF

Orientation of these caps does not matter.

Shunt Regulator and Small Transistor

Description, Marking

Programmable Shunt Regulator, TO-92 package,

look for "431" on the package.

for "5401" on the package

Rating, Marking

Electrolytic capacitor, 100 µF 63 V, radial leads

Electrolytic capacitor, 10 µF 63 V, radial leads

Electrolytic capacitor, 470 µF 63 V, radial leads

Electrolytic capacitor, 470 µF 100 V, radial leads

Page 10 of 18

Done? ()