2gig Technologies 2GIG-DW30-345 Instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación para Accesorios 2gig Technologies 2GIG-DW30-345. 2gig Technologies 2GIG-DW30-345 4 páginas. Outdoor wireless contact sensor
Imprimir página
Outdoor Wireless Contact | Installation Instructions
Mounting the Sensor on a Flat Surface.
1. Loosen the cover screw and remove the
Sensor Mounting Plate.
2. Ensure that the Magnet Direction Marks
are aligned toward the desired magnet
location.
3. Screw the Mounting plate into the
desired surface.
4. Replace the Sensor onto the Mounting
plate and tighten the cover screw.
5. Secure the magnet into place.
Magnet
direction
marks
Sensor and Magnet Mounting Height
Ideally, the Sensor and Magnet should be mounted on
surfaces of equal height.
When mounted at a level height, the 1/4" preferred mounting
height offset should be attained.
A height offset that exceeds 1/4" may decrease detection
capabilities.
Sensor and Magnet Mounting Distance
The preferred mounting distance between the Sensor and
Magnet is 1/4 inch.
The maximum gap is 2 inches.
2 Copyright © 2018 Nortek Security & Control LLC
Mounting the Magnet on a Flat Surface.
1. Ensure that the magnet marks are aligned
to the desired magnet location.
2. Mount the sensor into the desired
surface using the two screws.
Recommended Gap = 0.25"
Mounted Surface
Maximum Gap = 2"
1/4"
Recommended
Mounted Surface