HiB 52000 Guía de inicio rápido - Página 2

Navegue en línea o descargue pdf Guía de inicio rápido para Mobiliario interior HiB 52000. HiB 52000 4 páginas.

Please Note You may need to remove the door(s) to aid installation. This can be done by unclipping the hinges. (There is

a release catch at the back of the hinge see Fig.A). Once detached, gently extract the wire between the carcass and the

top of the door then disconnect the cable connector(s) (Ffigig.B). DO NOT FIT SHELVES AT THIS STAGE. Extra care must

be taken when handling cabinets with mirrored sides or diffusers, especially when picking up and putting down the

cabinet - do not pick up the cabinet by the diffusers.

Bracket clip (Fig A)

REAR VIEW

Mounting Points

Fixing Preparation (Fig C)

Fixing Brackets (Fig D)

Fixing Brackets (Fig F)

Wire connectors (Fig B)

Angle Adjustment

Claw In/Out

Adjustment

Hanger Adjustment (Fig E)

Wall Hung Installation

Position the cabinet in a suitable location

(according to the zonal diagram (Fig 1) on the

back page) ensuring that the mains supply cable is

within reach of the cable connection point of the

cabinet. Carefully mark the desired position of the

cabinet using a soft pencil, ensuring it is level.

2. Remove the cabinet from the wall and using a spirit

level, mark a horizontal line below the pencil mark,

taking into account the location of the mounting

points (Fig. C). Place brackets on the pencil

line paying attention to the distance between

the hangers on the cabinet. Carefully mark the

position of the holes using a soft pencil. (Fig. D).