ADEMCO LYNX Manual del sistema - Página 6
Navegue en línea o descargue pdf Manual del sistema para Sistema de seguridad ADEMCO LYNX. ADEMCO LYNX 14 páginas.
También para ADEMCO LYNX: Manual del usuario (17 páginas), Manual de inicio rápido (8 páginas)
Imprimir página
Ademco Lynx System Manual
Access Code Programming
Your system allows for up to 6 user codes for use by other users, however only the master user of the
system is the only one who can assign codes to secondary users, and is designated user no. 02; user no.
01 is the installer's code.
Babysitter Code (User 07): This code can be used to arm the system, but cannot disarm the system
unless the system was armed with this code. This code is typically assigned to someone (such as a
babysitter) who needs to arm/disarm the system only at certain times. The Babysitter Code is assigned to
User 07.
Duress Code (User 08): This feature is intended for use when you are forced to disarm or arm the system
under threat. When used, the system will act normally, but can silently notify the alarm monitoring
company of your situation, if that service has been provided Duress Code is assigned to User 08.
The Duress Code is useful only when the system is connected to an alarm monitoring company.
To Add/Delete a User or Change a User's Code
To add a user code:
1. Enter the [Master code] and press the [CODE] key.
2. Enter the user number and the user's code (03-08).
To delete a user code:
1. Enter the [Master code] and press the [CODE] key.
2. Enter the user's code (03-08).
3. Wait 3 seconds until the keypad beeps once before pressing any other key. The code will
automatically be deleted.
System Testing
Testing Your System
Testing allows for each protection point to be checked for proper operation. While the touchpad will beep
every 45 seconds during Test Mode, no alarm messages will be sent to the Customer Care Center. We
recommend testing the system once a week.
To Test the System:
1. Disarm the system.
2. Close all protected windows, doors, etc.
3. The "Ready" message should be displayed the green Ready indicator (if present on the keypad)
http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]