HiB Quantum 42500 Manual - Página 2
Navegue en línea o descargue pdf Manual para Mobiliario interior HiB Quantum 42500. HiB Quantum 42500 4 páginas. Aluminium cabinets
Imprimir páginaInstallation
1. Atomic & Electron Only: Attach the
LED light fitting on the top of the cabinet
using the pre-drilled holes and the screws
provided. Push the male and female
electrical connections together until they
'click' (Fig. A).
2. Position the cabinet in a suitable location
and carefully mark the position of the top of
the cabinet using a soft pencil.
3. Remove the cabinet from the wall and
using a spirit level, mark a horizontal line
50mm below the pencil mark. Hold the
mounting bracket in place with the holes
corresponding with the marked line. Ensure
the bracket is central, and mark the position
of the holes (Fig. B).
4. Before drilling, ensure there are no
hidden cables or pipes behind the
mounting points. Drill the required holes in
the marked positions. If drilling through tile,
use a ceramic drill bit. Insert the wall plugs
level with the surface of the wall. If fitting to
a tiled surface, wall plugs should be inserted
below the tile surface to avoid cracking.
NB. For plasterboard walls, specialist fixings
should be purchased, available from any
DIY or hardware store. Fix the bracket to the
wall using the screws provided.
5. Kore, Callisto, Quantum, Nitro, Atomic
& Electron: Temporarily hang the cabinet
on the top bracket, and position the bottom
mounting bracket into the slot underneath
the cabinet. Mark the position of the bracket
using a soft pencil, then remove the cabinet
from the wall (Fig. C 1).
Mercury & Jupiter: Temporarily hang the
cabinet on the top bracket and mark the
position of the bottom mounting hole onto
the wall. remove cabinet and drill into the
wall as per step 4 (Fig. C 2).
6. Kore, Callisto, Quantum, Nitro, Atomic
& Electron: Place the bottom bracket on
the previously marked line and mark the
positions of the holes. Using the same
method as before, drill the required holes
and attach the bracket to the wall using the
screws provided.
2
7. Atomic & Electron Only: This cabinet
is provided with an electrical supply
cable already fitted. This cable should be
connected to the household electrical
circuit, and connections should be made in
accordance with the latest IEE regulations.
This is a Class I product and must be
connected to Earth. Ensure the domestic
electrical mains supply to which the product
is being connected is turned off. Connect
the domestic mains supply according to
Figure 2 on the back page.
8. Hang the cabinet on the wall ensuring that
it is firmly located on both brackets. Align
doors according to Fig. D.
9. Starting with the top shelf, insert the shelf
supports in the desired position and put
shelf into place. repeat for remaining
shelves.
Atomic
&
Electron
Only
Attachment Light Fitting (Fig A)
=
Kore, Callisto,
Quantum,
Nitro, Atomic
& Electron
only
Attachment Brackets (Fig B)