GREAT PLANES Cosmic Wind Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES Cosmic Wind. GREAT PLANES Cosmic Wind 20 páginas.

❏

3. Using the elevator pushrod wire, position the control horn

so that the four pushrod holes are in line with the elevator hinge

line. Mark the location of the mounting holes onto the elevator.

Drill a 3/32" [2.5 mm] hole on the marks, drilling through the

elevator. Attach the control horn to the elevator using two

2-56 × 1/2" [12 mm] machine screws and the control horn

back plate. Remove the screws and apply a couple of drops

of thin CA to both holes to harden the wood. Then, reinstall

the control horn.

❏

4. Connect a servo to the elevator output on the receiver.

Switch on the receiver and transmitter and center the elevator

trims. Install a servo arm on the servo so that it is perpendicular

to the centerline of the servo.

❏

5. Position the elevator servo in the servo tray so that the

hole ¼" (7mm) from the center of the servo arm is inline with

the pushrod wire. The servos can either be glued to the servo

tray with medium CA or attached with 2 × 6 mm self tapping

screws. The screws do not require a pilot hole; just thread

them into the plywood tray.

❏

6. Apply a drop of threadlocker to two cap screws and install

them into two wheel collars. Slide the two wheel collars over

the elevator pushrod.

❏

7. Enlarge the hole in the servo arm with a #60 or 3/64"

[1mm] drill bit. Insert the Z-bend of a 1 × 25 mm pushrod into

the hole ¼" (7mm) from the center of the elevator servo arm.

Slide the wheel collars over the two pushrods, positioning

them so that they are close to the ends of the two pushrods.

Tighten the cap screws against the pushrods.

❏

8. Switch your radio system on and center the servo arm

and elevators. Tighten the cap screws against the pushrods.