GREAT PLANES Fling 2m ARF Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES Fling 2m ARF. GREAT PLANES Fling 2m ARF 16 páginas.

❏

5. With the inner left wing section flat on your workbench

and the center joint on the wax paper, raise the right wing tip

9-1/2" [241 mm] to properly set the dihedral. Block the raised

right wing at the desired height and make a mental note of the

position needed for it to maintain that dihedral.

❏

6. Remove the joiner from the wings. Cover the joiner, left

and right wing root ribs and pockets in the wing panels with

a moderate, but not excessive amount of 30-minute epoxy.

Join the wing halves together making sure the wing joiner is

centered. Ensure that the left wing remains flat and that the

right wing tip is 9-1/2" [241 mm] from your workbench and

can remain that way undisturbed until the epoxy has

hardened. Remove any excess epoxy with a paper towel

and denatured alcohol, being careful not to disturb the joint.

Hint: Use masking tape to hold the wing together while the

epoxy hardens.

❏

7. Glue the plywood TE support centered on the TE of

the wing with CA.

❏

8. Glue the carbon fiber wing dowels into the fuse with

a small amount of thin CA. Be sure the length of the carbon

on each side is equal.

Assemble the Tail

❏

1. Locate the two small holes in the stab. Remove the

covering from these holes using a sharp hobby knife.

❏

2. Insert the fin posts into the holes in the stab as shown.

These two parts joined together will be referred to as the tail

assembly from this point.

❏

3. Attach the tail assembly to the tail boom as shown.